User manual CLARION OHM642

[. . . ] Please fill out and send in the enclosed warranty card to protect your purchase and aid in warranty service. Also, save your original sales receipt as proof of purchase. . 1 . 2 . 2 . 2 . 3 . 3 . 4 . 4 . 4 . 5 . 6 PRECAUTIONS The set is for use in DC 12V, negative ground vehicles. Do not operate the set in ways other than described in this guide. [. . . ] PACKAGE CONTENTS 6. 4" monitor 5m long cable with 5 male connectors (A/V, Power/Ground, 3. 5m IR) Mounting Gasket Mounting Bracket Hardware Owner's Manual Warranty Card BUTTON AND CONNECTOR LOCATIONS 3 5 4 1 2 7 6 1 2 3 4 Dome Light Switch Monitor Release Button Picture Select Up Picture Select Down 5 6 7 IR Sensor Dome Light Connector 8 Pin DIN Pigtail OHM642 WIRING PRECAUTIONS Read all wiring precautions. If you are not sure of the connections, contact your authorized Clarion dealer. Disconnect the negative (-) lead of the battery before making any power connections. When creating passage holes for the power wires, use grommets to eliminate any sharp edges created during drilling. This will protect the wire from being nicked and causing a short circuit. When connecting the ground lead, fasten the ground lead (black) securely to a clean metal plate on the vehicle. NOTE: The OHM642 monitor displays video images only. Refer to the owner's manual of the connected device for information on audio output. INSTALLATION The OHM642 is an overhead, fold-down 6. 4" monitor with an Infrared (IR) eye. It will accept a video signal from any video source with composite video out. The IR eye will work directly with any Clarion video source product with an IR Eye Input. Look over the vehicle for a location for the monitor. Each vehicle is different and locations will vary. Make sure the monitor will not interfere with the driver. Once a location has been determined, connect the IR, A/V RCAs and power cables to the designated sources. Feed the cables through the hole in the mounting bracket and screw the bracket to the headliner. Use short screws so as not to damage the roof. Plug the cable into the monitor's 8 Pin Din connector. Mount the monitor with the provided hardware. 8 1 2 3 4 5 6 7 8 Pin DIN Mini Connector DC 12V IR Out DC 12V Ground Video Input A/V Signal Ground Audio R Input ACC Control Audio L Input POWER CONNECTOR IR REMOTE OUT AUDIO R INPUT AUDIO L INPUT VIDEO INPUT OWNER'S MANUAL MOUNTING OPTIONS The OHM642 is an overhead, fold-down 6. 4" monitor with an Infrared (IR) eye. It will accept a video signal from any video source with composite video out. [. . . ] CARE AND MAINTENANCE Cleaning the cabinet: Use a soft, dry cloth to gently wipe off any dirt. Do not use benzene, thinner, car cleaner, etc. , as these substances may damage the cabinet or cause the paint to peel. Cleaning the LCD panel: Use a soft, dry cloth to gently wipe off any dust. The surface is easily scratched; do not rub it with hard objects. OHM642 SPECIFICATIONS GENERAL SPECIFICATIONS: Power Requirement: Power Consumption: Weight: Dimensions: Operation Temperature: Supplied Accessories: DC 12V (9-16V) 0. 8A Max. [. . . ]