User manual CLARION OHM653

[. . . ] Warning! THE CLARION OHM653 OVERHEAD VIDEO MONITOR IS DESIGNED TO BE VIEWED BY REAR-SEAT OCCUPANTS ONLY!CLARION VIDEO PRODUCTS ARE NOT INTENDED FOR VIEWING BY THE DRIVER WHILE THE VEHICLE IS IN MOTION. SUCH USE MAY DISTRACT THE DRIVER OR INTERFERE WITH THE DRIVER'S SAFE OPERATION OF THE VEHICLE, AND THUS RESULT IN SERIOUS INJURY OR DEATH. CLARION DISCLAIMS ANY LIABILITY FOR ANY BODILY INJURY, INCLUDING FATALITIES, OR PROPERTY DAMAGE THAT MAY RESULT FROM ANY IMPROPER OR UNINTENDED USES OF THIS PRODUCT. Table of Contents 1. [. . . ] Each time this button is pressed, the unit will step to the next setting mode, and the screen will display the value of the selected setting. These adjustment settings are: Brightness Contrast Color Tint Mem Reset (resets above to original values) When the "MEM RESET" option is displayed on the screen, pressing either the [+] or [-] buttons will reset all settings to their original factory values. If you do not wish to reset the settings, either press the [PICTURE] button again, or wait for the monitor to exit the picture adjustment mode automatically. If the "MEM RESET" option is used and the OHM653 is set to Source 2, the monitor will revert to the default setting of Source 1. If there is no active input on Source 1, the screen may go dark. If this happens, press the [SOURCE] button to switch the monitor back to Source 2. · 6 OHM653 OHM 653 122302. p65 6 12/23/02, 10:42 PM 6. Before Starting Read these instructions and the following precautions carefully. Be sure to disconnect the battery (-) terminal before starting. This is to prevent short circuits during installation. rough cloth, thinner, benzene, alcohol, or other solvent. The screen surface is easy to scratch - do not rub when cleaning. 2. Package Contents 1 2 3 4 5 6 OHM653 overhead monitor unit Soft trim ring Mounting bracket Wiring harnesses Remote control Owner's Manual / Installation Guide 3. Never install this monitor where it is visible from the driver's seat, or where it could injure any vehicle occupant in case of an accident. Ensure that your installation does not create risk of headstrike injury, and that the monitor will remain securely mounted in the case of an accident or sudden maneuver. Precautions · This unit is exclusively for cars with a negative ground, 12V power supply. There are no user-serviceable parts inside. If you require asistance, consult your Clarion dealer or an authorized Clarion service center. · Use a soft, dry cloth to clean the screen. Never use a OHM653 7 OHM 653 122302. p65 7 12/23/02, 10:42 PM 4. Installing the OHM653 Prepare the vehicle for installation by carefully removing vehicle interior trim panels as necessary. Route wire harnesses away from sharp edges, and ensure that no harnesses will be pinched or pierced during reassembly. Temporarily remove the OHM653 dome light lenses and bulbs, so that the rear mounting screws can be accessed. Note: · The wiring of the OHM653 must be completed, and the wiring harness plugged in, prior to the final installation of the monitor into the ceiling. However, since some vehicles will require custom work or other modifications, this manual discusses physical installation first. Always complete your wiring before final assembly of the monitor into the ceiling of the vehicle. light - for this reason, the OHM653 has dome lights built in which can replace the original lights. WARNING! [. . . ] If the temperature is outside this operating range, the unit will not turn on, or the screen may be slow to react to image changes. The monitor will function normally once it returns to its proper operating temperature range. Note: With a DVD player and a widescreen DVD disc, there are black bars on the screen. Change the TV display mode to "Wide" in the DVD player's Setup menu. After changing this setting, if there are still black bars, press the [WIDE/NORMAL] button on the OHM653 remote control. · The technical data and the design of the equipment may change for the sake of technical improvements without prior notice. OHM653 15 OHM 653 122302. p65 15 12/23/02, 10:42 PM LIMITED WARRANTY INFORMATION For USA and Canada only This product is warranted against all defects in material workmanship for a period of one year from the date of original purchase. [. . . ]