User manual CLARION PSWDRAM INSTALLATION MANUAL

[. . . ] The woofer supplied with this system uses a voice coil with rated impedance of 2 ohms, and therefore is not considered a standard woofer. Replacing the woofer with any driver having an impedance greater than 2 ohms will yield lower power output from the amplifier, and is not recommended. PROCEDURE Proper installation of this product requires proper tools and knowledge of car audio principles. If you are not comfortable performing any of the outlined tasks below, contact a professional installation facility to perform the work. OUTLINE · · · · · · Remove the head unit. [. . . ] ·STEP 4: Connect the amplifier ground wire to a clean chassis ground near the subwoofer enclosure. STEP 5: TEST and SET the GAIN. Turn on the system and be sure all speakers are working properly. Set the subwoofer amplifier gain to a suitable level. Ib. WIRING USING THE SUPPLIED HARNESS · STEP 1: Remove the Radio. Yellow: Connect to Constant 12V Power Black: Connect to Radio Ground or Chassis Blue: Connect to Amp/Antenna Turn-on Lead Green: Connect to Left Rear Speaker (+) Positive Lead Green/Black: Connect to Left Rear Speaker (-) Negative Lead Violet: Connect to Right Rear Speaker (+) Positive Lead Violet/Black: Connect to Right Rear Speaker (-) Negative Lead · STEP 3: Route the wire harness from the radio to the rear passenger side of the vehicle. ·STEP 4: Connect the amplifier ground wire to a clean chassis ground near the subwoofer enclosure. STEP 5: TEST and SET the GAIN. Turn on the system and be sure all speakers are working properly. Set the subwoofer amplifier gain to a suitable level. 2 Extended Cab Instructions: II. RUN WIRE HARNESS A. Run harness to the rear of the vehicle underneath the rear folding seat on the driver's side of the truck. III. Place enclosure upright so that the rippled surface is down. Position brackets so that the vertical slots line up with the angled/lower set of dimples on the enclosure. Attached brackets using the supplied pilot point Phillips screws, screwing through the locating dimples on the enclosure (the dimples should be centered in the vertical slots on the bracket). IV. Place enclosure into the vehicle, the subwoofer will fire down (the correct position of the enclosure is underneath the rear folding seat on the driver 's side). Plug in the wire harness to the enclosure (ground the 8" black wire on the wire harness). Plug in the "T" harness behind the radio (or hard wire the supplied "pigtail" harness to the factory wiring). Adjust subwoofer gain (gain pod is located on the amplifier next to the wire harness connector, and is adjustable with a Phillips screw driver). V. ATTACH THE ENCLOSURE TO THE VEHICLE A. [. . . ] Plug in the wire harness to the enclosure (ground the 8" black wire on the wire harness). Plug in the "T" harness behind the radio (or hard wire the supplied "pigtail" harness to the factory wiring). Adjust subwoofer gain (gain pod is located on the amplifier next to the wire harness connector, and is adjustable with a Phillips screw driver). V. ATTACH THE ENCLOSURE TO THE VEHICLE A. [. . . ]