User manual CLARION RK20

[. . . ] Use of this product in a standard transmission vehicle is dangerous and contrary the product's intended use . © 2008 Directed Electronics--all rights reserved 5 Transmitter Functions The receiver uses a computer-based learn routine to learn the transmitter buttons . Standard configuration Button The door lock is controlled by pressing Button . and HOLD . Press The remote panic is controlled by pressing and holding to reset the panic mode . Button The door unlock is controlled by the button . Button The channel 2 output or trunk release is controlled by the button . Button The remote start function of your system is controlled by pressing . Buttons mode . + When simultaneously pressed these buttons control the timer Buttons + © 2008 Directed Electronics--all rights reserved When simultaneously pressed these buttons control the car finder 6 mode . [. . . ] To avoid being locked out of the vehicle, do not turn the ignition on until you are ready to drive the vehicle . 10 © 2008 Directed Electronics--all rights reserved Remote start This feature allows you to remotely start and run your vehicle for a programmable period of time . This makes it possible to warm up the engine, as well as adjust the interior temperature of the vehicle with the climate control system . If interior heating or cooling is desired, the climate controls must be preset, and the fan blower must be set to the desired level prior to remote starting the vehicle . IMPORTANT!(1) Never remotely start the vehicle with the vehicle in gear, and (2) Never remotely start the vehicle with the key in the ignition . To remote start the vehicle: 1 . Press on the transmitter once within 3 seconds . The parking lights flash to confirm remote start operation . Once the vehicle has started, it will run for the pre-programmed period of time (12, 24, or 60 minutes) or until a shutdown input is triggered . This can be set to minute increments by your installer . When you are ready to drive the vehicle: 1 . Insert the ignition key and turn it to the ON (not the START) position . 2 . Press the brake pedal . NOTE: If the brake pedal is pressed before the key is in the ON position, the engine will shut down . © 2008 Directed Electronics--all rights reserved 11 While the vehicle is running during remote start operation, the system will monitor the vehicle and will automatically shut down the engine if the system receives any of the following shut-down inputs: The brake pedal is pressed . The shutdown toggle switch is put into the ON position . The pre-programmed run time has elapsed . The button is pressed once within 3 seconds . Car finder Car finder allows you to locate your vehicle, by having the system flash the parking lights on your vehicle . . To activate: Press and release the and buttons at the same time . The lights flash 5 times slowly allowing you to locate your vehicle . Timer Mode By pressing the remote and buttons the parking lights will flash 4 times and then start the vehicle and run for the set duration . The rear defogger output will once again activate when the vehicle is remote started . + + buttons NOTE: If the remote start is on the lights will turn off then flash 3-times before returning to their normal output and the defogger output will activate as programmed . Valet Take-Over The Valet Take-Over feature allows the vehicle to remain running after the key has been removed from the ignition . This feature is useful for occasions when you wish to exit and lock the vehicle for short periods of time, but would like to leave the motor running and the climate controls on . 14 © 2008 Directed Electronics--all rights reserved To perform Valet Take-Over: 1 . Before turning off the engine, press and release tary switch) . Turn the ignition key to the OFF position . (The engine will stay running . ) The engine will run until the pre-programmed time elapses or a shut-down input is received . (See remote start section for a complete list of shut-down inputs . ) NOTE: This feature will not work if the brake pedal is being pressed . once within 2 seconds (or press and release the optional Momen- © 2008 Directed Electronics--all rights reserved 15 Programming Options Programming options control your system's normal, operational set-up . [. . . ] Clarion will not assume any responsibility for any loss or damage incurred in shipping. ALL IMPLIED WARRANTIES EXCEPT TO THE EXTENT PROHIBITED BY APPLICABLE LAW SHALL HAVE NO GREATER DURATION THAN THE WARRANTY PERIOD SET FORTH ABOVE. UNDER NO CIRCUMSTANCES SHALL CLARION CORPORATION BE LIABLE FOR ANY LOSS OR DAMAGE, DIRECT OR CONSEQUENTIAL, ARISING OUT OF THE USE OR INABILITY TO USE OF THE PRODUCT. BECAUSE SOME STATES DO NOT ALLOW LIMITATIONS ON HOW LONG AN IMPLIED WARRANTY LASTS OR © 2008 Directed Electronics--all rights reserved 21 EXCLUSIONS OR LIMITATIONS OF INCIDENTAL OR CONSEQUENTIAL DAMAGES, THE ABOVE LIMITATIONS OR EXCLUSIONS MAY NOT APPLY TO YOU. [. . . ]