User manual CLARION S100

[. . . ] Model S100 O Owner's Guide limited lifetime consumer warranty This Ungo Pro Security system is warranted against defects in material and workmanship. The main unit is covered by this limited lifetime warranty. This Limited Lifetime Warranty applies to Ungo Pro Security systems that have been installed by an authorized Ungo Pro Security dealer. This warranty is to the Original Purchaser ("Owner") and to the original vehicle in which it was installed into. [. . . ] The control unit knows what the next codes should be. This helps to keep the remote "in sync" with the control unit even if you use the remote control out of range of the vehicle. However, if the remote has been pressed many times out of range of the vehicle, or if the battery has been removed, it may get out of sync with the control unit and fail to operate the system. To re-sync the remote control simply press and respond to the remotes normally. of the remote several times within range of the vehicle. The alarm will automatically re-sync high frequency Your system transmits and receives at 434 MHz. This provides a cleaner spectrum with less interference and a more stable signal. Enjoy a phenomenal increase in range ­ even in areas with high radio interference. 17 individual remote recognition Individual remote recognition is a feature available. Using the Pro Security Programmer, a hand-held programming tool, your dealer can program many of the system settings. The programmer makes it possible to program different settings for each remote that is used with the system. Then, whenever a specific remote is used, the system will recall the settings assigned to that remote. Individual recognition lets up to four users of the system have different settings that meet their specific needs. It is almost like having four separate alarms in your vehicle, one for each user. note: This individual recognition cannot be programmed without a Pro Security Programmer and the necessary software. Check with your dealer for more information. power-up This system will store its current state to non-volatile memory. If power is lost and then reconnected, the system will recall the stored state from memory. This means if the unit is in valet mode and the battery is disconnected for any reason, such as servicing the car, when the battery is reconnected the unit will still be in valet mode. This applies to all states of the system including arm, disarm, anti-carjacking, and valet mode. 18 power saving mode Your system will automatically enter a power saving mode while armed or in valet mode, after a period of time in which no operation has been performed. This lowers the current draw to the vehicle's battery. Power Saver mode takes over under the following conditions: Power saving when the system is armed: After the system has been armed for 24 hours, the LED will flash at half its normal rate, decreasing the system's current draw. Power saving in valet mode: When the system enters valet mode the LED illuminates steadily. If the vehicle is not used (ignition is not turned on) for a period of one hour while the system is in valet mode, the LED will shut off. If the system remains in valet mode, the LED will come back on the next time the ignition is turned on and then back off. 19 programming options Programming options control what your system does during normal operation, and require few or no additional parts. [. . . ] A remote function can also be used to turn on your parking and headlights for a programmed time. Power Trunk Release: The channel two output of the system can operate a factory power release for the vehicle's trunk or hatch. (An additional relay may be required. ) If the factory release is not power activated, then a trunk release solenoid can often be added. Power Window Control: Power window control can be provided by one of two systems. [. . . ]