User manual CLARION S660
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual CLARION S660. We hope that this CLARION S660 user guide will be useful to you.
Lastmanuals help download the user guide CLARION S660.
You may also download the following manuals related to this product:
CLARION S660 INSTALLATION GUIDE (1142 ko)
Manual abstract: user guide CLARION S660
Detailed instructions for use are in the User's Guide.
[. . . ] Model S660
O Owner's Guide
limited lifetime consumer warranty
This Ungo Pro Security system is warranted against defects in material and workmanship. The main unit is covered by this limited lifetime warranty. This Limited Lifetime Warranty applies to Ungo Pro Security systems that have been installed by an authorized Ungo Pro Security dealer. This warranty is to the Original Purchaser ("Owner") and to the original vehicle in which it was installed into. [. . . ] If the system is triggered and the siren has been sounding for longer than six seconds, pressing on the remote will stop the trigger and return the unit to the armed state. The system will not disarm, but rather reset. This prevents you from disabling the system should you wish to disarm it without visually checking the vehicle. Pressing after resetting the system will disarm the system; pressing this button during the first six seconds of the triggered sequence will disarm the security system immediately. The six second timer is provided for your convenience, in case the system is accidentally triggered.
© 2005 directed electronics, inc.
25
disarming without a remote
If your remote is lost or damaged, you can manually disarm your vehicle security system. To disarm the system without a remote, you must have the vehicle's ignition key and know where the Valet® button is located. Be sure to check with your installer at the time of installation for both the location and the preset response (1-5 presses) of the Valet® button. To disarm the security system, turn the ignition to the ON position. Press the Valet® button the preset number of times (one to
DRW-35
five times) within 15 seconds. After five seconds, the system will disarm. If the system does not disarm, you may have waited too long; turn the ignition off and on and try again.
Location of Valet® Button_________________________________ Number of Presses_____________________________________
important!The Valet® button can be programmed to respond to 1-5 presses for the disarm function. You must check with the installer to verify the programming for your individual unit.
26
© 2005 directed electronics, inc.
silent mode
To temporarily turn off the arm or disarm chirps, use Silent ModeTM. Simply press for less than one second before arming or disarming, and the confirmation chirp(s) will be eliminated for that one operation only. If you want the arm/disarm chirps turned off permanently, your dealer can do this for you.
note: The Warn Away® response to lighter impacts is bypassed if the system is armed using Silent Mode. This ensures that no chirps will be emitted by the siren in an area you want chirp-free. The system is still fully capable of triggering. Only the Warn Away® response is bypassed.
panic mode
If you are threatened in or near your vehicle, you can attract attention by triggering the system with your remote. Just press for two seconds, and you will enter Panic Mode. The siren will sound and the parking lights will flash for the programmed siren duration. To stop Panic Mode at any time, press the remote again.
note: Once panic mode has been entered, the siren will sound for the programmed duration.
on
The LCD 2-way remote will beep (or vibrate) continuously when the system enters panic mode. The 2-way remote will not generate a page notification when panic mode is exited.
© 2005 directed electronics, inc.
27
valet® mode
You can prevent your security system from automatically arming and triggering by using Valet® Mode. [. . . ] For other systems, additional parts may be required.
Power Trunk Release: The accessory output of the system can op-
erate a factory power release for the vehicle's trunk or hatch. Although the on-board relay can control most power trunk releases, sometimes an optional relay is required. If the factory release is not power-activated, Directed®'s 522T trunk release solenoid can often be added.
Power Window Control: Automatic power window control is pro-
vided with the 529T and 530T systems. These can operate power windows, and can roll them up automatically when the system is armed, roll them down, or both up and down.
40
© 2005 directed electronics, inc.
glossary of terms
Control Unit: The "brain" of your system. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE CLARION S660 Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service. Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual CLARION S660 will begin.