User manual CLARION SIR-CL1 INSTALLATION MANUAL

[. . . ] SIRIUS Satellite Radio User Manual Thank you for purchasing this product. Please read this user's manual in its entirety before operating this equipment. After reading this manual, be sure to keep it in a handy place (e. g. , glove compartment). Check the contents of the enclosed warranty card and keep it carefully with this manual. Contents 1. [. . . ] · Locations where the unit will hamper or interfere with driving. · Locations where the unit could injure passengers if the car stops suddenly. · Locations exposed to direct sunlight or hot air from the heater, etc. · Locations where the unit may be exposed to rain or water. Be sure to use the included screws and brackets. Screws other than those supplied could damage the unit. 4. When drilling holes to mount the receiver, be sure to check beforehand that there are no obstructions or items on the other side that could be damaged (fuel tank, wire harnesses or other electronic devices). Accessories Mounting bracket . . . . . . . . . . . . . . 2 pieces Mounting screw . . . . . . . . . . . . . . . . . 4 pieces Canoe clip . . . . . . . . . . . . . . . . . . . . . . . . . 4 pieces CeNET cable . . . . . . . . . . . . . . . . . . . . . 1 piece 4 Installation Example (Installing the unit under the driver's seat) 1. Attach the mounting brackets to the sides of the SIR-CL1 using the screws provided. Drill holes in the floor mat to match the positions of the holes in the mounting brackets . Insert the canoe clips from the rear of the floor mat and install the SIR-CL1. There are three mounting holes on each side of the SIR-CL1. Select the appropriate holes to match to the installation location. Connection Example and Identification of Parts CeNET input/output terminal Connect to the main unit or CD/MD changer using the CeNET cable as specified . RCA pin terminals These are used to output audio when the DSC920S (sold separately) is used to operate the receiver. ANTENNA terminal Connect to the SIRIUS antenna (sold separately) COMMANDER Controller terminal Connection for DSC920S (sold separately) COMMANDER Power Supply terminal Used only when operating the SIR-CL1 with the DSC920S (sold separately) CeNET/STANDALONE switch This switch is used to select the operating type: CeNET (headunit) or STAND ALONE (DSC920S) 5 How to Connect 1. CeNET Cable Orient the CeNET cable in the direction shown in the figure and insert it until it is locked in position. To remove the CeNET cable, pull it by lightly grasping in your fingers. SIRIUS antenna Make sure power is "Off". Connect a SIRIUS antenna (sold separately) to the SIRIUS antenna terminal and press until locking tab engages. To disconnect, make sure power is "Off", then press the rear of the locking tab to release. 6 4. [. . . ] The CAT indicator lights on models without a function mode indication. Press the [RDM] (RD) button again to cancel. Notes: · When the category selection mode is entered, the category of the current or last received channel is displayed first. or button within 7 seconds after a category has been set to · Press the continue seeking channels up or down. [. . . ]