User manual CLARION SR1000

[. . . ] Model SR1000 O Owner's Guide limited lifetime consumer warranty This Ungo Pro Security system is warranted against defects in material and workmanship. The main unit is covered by this limited lifetime warranty. This Limited Lifetime Warranty applies to Ungo Pro Security systems that have been installed by an authorized Ungo Pro Security dealer. This warranty is to the Original Purchaser ("Owner") and to the original vehicle in which it was installed into. [. . . ] Turn the ignition key to the OFF position. (The engine will stay running. ) The engine will run until the pre-programmed time elapses or a shut-down input is received. (See the previous remote engine start section for a complete list of shut-down inputs. ) 2. 3. note: This feature will not work if the brake pedal is being pressed. 18 short-run/turbo Short run turbo mode keeps the engine running after arriving at you destination for a programmable period of 1, 3, 5 or 10 minutes. This allows the system's timer to conveniently cool down the turbo after you have left the vehicle. Remove your foot from the brake pedal and leave the engine running. and buttons at the same The lights will flash to indicate the remote engine start has entered short run turbo mode. Turn off the key, the engine will keep running. The engine will turn off after the programmed run time. timer mode By pressing the remote and buttons the parking lights will flash 4 times and then start the vehicle and run for the set duration. The remote engine start can be shut off by the remote by pressing the remote start button and remain in timer mode, but if any other shut down zones or the ignition becomes active the timer mode will cancel. The vehicle will confirm with 4 parking light flashes. The system will start the car and will run for the specified duration, unless shut down by the remote start button . 19 . If shut down with the remote start button will remain in timer mode. 5. the system The system will start every 3 hours until canceled by the brake, hood, or neutral safety shut-down wires. important!Timer Mode should be used only in open areas. Never start and run the vehicle in an enclosed space such as a garage or carport. To exit timer mode, turn the ignition switch on any time the engine is running. The parking lights will flash 4 times, indicating timer mode has been exited. safety features This system has several important safety features to ensure proper operation of the motor and prevent accidental damage to the engine or its components. starter anti-grind circuitry Whenever the vehicle is remote started, advanced anti-grind circuitry prevents the starter from engaging, even if the key is turned to the start position. This prevents damage to the starter motor if the key is turned to the start position during remote engine start operation. 20 disabling the remote engine start system This feature allows your system's remote engine start unit to be temporarily disabled to prevent the vehicle from being remote started accidentally. This feature is useful if the vehicle is being serviced or stored in an enclosed area. To disable the remote engine start, move the shutdown toggle switch to the OFF position. The switch can be installed in a location of your choice. Check with your installer for recommended locations. [. . . ] Input: A physical connection to the system. An input can be provided by a sensor, pinswitch or by existing systems in the vehicle, such as ignition or courtesy lights. LED: A blue light mounted at a discretionary location inside the vehicle. It is used to indicate the status of your system. [. . . ]