User manual CLARION SR5000

[. . . ] Model SR5000 O Owner's Guide limited lifetime consumer warranty This Ungo Pro Security system is warranted against defects in material and workmanship. The main unit is covered by this limited lifetime warranty. This Limited Lifetime Warranty applies to Ungo Pro Security systems that have been installed by an authorized Ungo Pro Security dealer. This warranty is to the Original Purchaser ("Owner") and to the original vehicle in which it was installed into. [. . . ] After five seconds, the system will disarm. If the system does not disarm, you may have waited too long; turn the ignition off and on and try again. Location of override switch_________________________________ Number of Presses_____________________________________ 25 important!The override switch can be programmed to respond to 1-5 presses for the disarm function. You must check with the installer to verify the programming for your individual unit. silent arm/disarm To temporarily turn off the arm or disarm chirps, use silent arm/disarm. Simply press for less than one second before arming or disarming, and the confirmation chirp(s) will be eliminated for that one operation only. When silent arm/disarm has been used the silent arm/disarm mode icon will indicate silent arm/disarm. If you want the arm/disarm chirps turned off permanently, your dealer can do this for you. note: The warning response to lighter impacts is bypassed if the system is armed using silent arm/disarm. This ensures that no chirps will be emitted by the siren in an area you want chirp-free. The system is still fully capable of triggering. Only the warning response is bypassed. 26 panic mode If you are threatened in or near your vehicle, you can attract attention by triggering the system with your transceiver. Just press for two seconds, and you will enter panic mode. siren will sound and the parking lights will flash. To stop panic mode press note: Once panic mode has been entered, the siren will sound for 30 seconds. The transceiver will beep (or vibrate) continuously when the system enters panic mode. The transceiver will not generate a page notification when panic mode is exited. override mode You can prevent your security system from passive arming by using override mode. This is very useful when washing the vehicle or having it serviced. In override mode, the security system will not arm, even with the transceiver, but all convenience functions (door locks, trunk release, remote starting, etc. ) will continue to work normally. To enter or exit override mode: 1. Press and release the override switch within 10 seconds. DRW-35 27 The status LED will light solidly if you are entering override mode, and it will go out if you are exiting override mode. The transceiver will not generate a page notification when entering or exiting override mode using the override switch. To enter or exit override mode using the transceiver: 1. again. The status LED will light solidly if you are entering override mode, and it will go out if you are exiting override mode. The transceiver will generate alarm/disarm page notifications since the observing buttons are used when entering and exiting override mode. The status LED is the only way to ensure the system has entered/exited override mode. remote engine start This feature allows you to remotely start and run your vehicle for a programmable period of time. This makes it possible to warm up the engine, as well as adjust the interior temperature of the vehicle with the climate control system. [. . . ] While the remote start system is running the engine, the parking lights of the vehicle can flash on and off or come on and light steadily. 44 security & convenience expansions Listed below are some of the many expansion options available. Please consult your dealer for a complete explanation of all the options available to you. Audio Sensor: Metal on glass, glass cracking, and breaking glass produce distinctive acoustic signatures. The audio sensor uses a microphone to pick up sounds, then analyzes them with proprietary acoustic software to determine if the glass has been struck. Backup Battery: The keeps the system armed, triggers the alarm and keeps the starter interrupt active if main battery is disconnected. Hood Lock: Prevents the vehicle's hood from being opened without a key, keeping thieves away from the system's siren, the battery connections, and other components under the hood. Field Disturbance Sensor: An invisible dome of coverage is estab- lished by installing the "radar" sensor. Your system can react to any intrusions into this field with the full triggered sequence. Power Locks: This system offers lock outputs that can control some manufacturers' power door lock systems. [. . . ]