User manual CLARION TTX001 INSTALLATION MANUAL

[. . . ] Do not install monitors displaying video information anywhere that would permit viewing by the driver. Monitors must not be located in the motor vehicle at any point forward of the back of the front seats. Monitors must never be used in any manner that will distract driver or interfere with driver's safe operation of the motor vehicle. Be careful not to run down the car battery while using the unit with the car stopped. [. . . ] At the OHM641, plug the IR extension and power cables supplied with the OHM641. Run these cables to the back of the video player. Plug the video RCA into the video output of the player. Plug the IR extension into the other leg of the Y connector. These wires will be run to the radio location. Plug the audio RCA cable into the audio output of the player and run the audio RCA and main power cables to the radio location. Remove the radio and plug the audio RCA into the FM100S audio inputs. Mount the switch for the FM100S and run its power wire to the radio location. The power and ground wires of the TTX001, video player, OHM641 and the FM100S can be joined and connected to the radio accessory and ground wires. Plug the vehicle antenna into the antenna input of the FM100S. Plug the antenna output of the FM100S into the radio. The FM 100S has a two position switch to select the modulation frequency. Pick the frequency that has the least amount of radio reception and set that frequency on the modulator and into a radio preset memory. Operation Similar to a home system, the VDH9600 allow their auxiliary A/V inputs to loop through to their A/V outputs when they are not playing a video tape. · Because the IR lines have been linked together, each component can be controlled by its respective remote control when pointed to the IR eye located on OHM641. · Turn the vehicle ignition switch to the accessory position. Point the video player remote at the IR eye and press power to turn on the player. Point the remote (RC-300) at the IR eye and press power to turn on the tuner. · You should now see the TV displayed on the monitor. · Turn the modulator and the radio on and tune to the modulated frequency. [. . . ] The signal might be reflected from mountains or buildings. Check by changing location or direction. Problem: The picture has a flecked or lined pattern. Solution: · There may be effects from cars, trains, neon signs, or other interfering signals. [. . . ]