User manual CLARION VMA573

[. . . ] The Clarion VMA 573 and VMA773 monitors are only designed to be viewed by rear-seat occupants. Digital video products are not intended for viewing by the driver while the vehicle is in motion. Such use may distract the driver or interfere with the driver’s safe operation of the vehicles, and thus result in serious injury or death. Such use may also violate government law. [. . . ] When you turn the vehicle’s ignition off , the monitor automatically shuts off. Switching between video sources If your vehicle has two video sources, for example, a DVD player goes to AV1 and a game console goes to AV2, you can easily switch between them. The monitor will display AV1 and press SOURCE key to select the input for AV2 for game console. Press SOURCE again to select AV1 input for DVD player. Note : If you’re using only one video source, the screen remains dark when you select the unavailable source. Default setting for VMA573 / VMA773 is AV1 for normal case. 16 Playing two videos or games at once If your vehicle is equipped with two LCD monitors in the headrests and two video source units, two different videos or games can play at the same time. Each monitor transmits the infrared audio signal over its own channel, A or B. When a vehicle has two monitors, the default is to configure the monitor in the driver’s headrest to use IR channel A, and the monitor in the passenger’s headrest to use IR channel B. Press MENU key several times to locate the IR CH option. Press down ( ) or up ( ) to alternate between A and B or OFF. Note: You don’t need to select the IR channel if your vehicle has only one monitor. Disabling automatic power on Your monitor is preset at the factory to switch on when you turn on your vehicle’s ignition. However, you can set it up to remain the VMA off until you press POWER on the monitor. Press MENU several times until you reach the AUTO POWER option. Press down ( ) or up ( ) to turn automatic power ON and OFF. Press MENU several times to locate the RESET option. Press either down ( ) or up ( ) to reset the settings. If you don’t wish to reset the settings, either press MENU again or wait for the monitor to exit the picture adjustment menus automatically. Note : If you reset the options and the monitor was set to source2 ( AV2 ), the monitor reverts to the default setting of AV1. If there is no active video source on AV1, the screen may go dark. Press SOURCE to switch the monitor back to AV2. [. . . ] Replace the external fuse with a fuse of the same amperage. Press SOURCE to make sure the proper input is selected. If there is still no picture, press MENU. If the menu appears, check the source unit and video connections. [. . . ]