User manual CLATRONIC AR 820

[. . . ] 82 68 INSTALLATION Tips: • Select a mounting position in which the unit does not interfere with the normale driving operation • Connect all electric cables before the final installation and check for proper function. €¢ Use only supplied accessories for correct installation. The use of unauthorized parts can cause malfunctions. €¢ Contact your dealer if holes have to be drilled or other modification to the vehicle are necessary. [. . . ] Audio In You can connect a portable audio player via AUX IN (23) on the front panel. Press and hold until “Manual…” is displayed; you are now in manual mode. The unit returns to auto search mode and “AUTO…” is displayed if no button is pressed for a few seconds. The radio scans the frequencies and measures the signal strength during one seach cycle. The 6 strongest stations are saved in the preset memory. - Briefly press AS/PS (20) to recall a preset station. The corresponding preset number P1~P6 is displayed. SCAN Press SCAN (18) to access search mode and to scan for a strong station. The unit plays the station and the frequency flashes five times on the display). presets Press one of the number buttons (1-6) to select a preset station. Press and hold (until a second beep sounds) to store the current station under the selected preset number. In this menu use the volume knob (26) to select the station and (1) tune into the station. €¢ TA-SEEK: SEEK/ALARM a) TA SEEK mode: If a new station does not broadcast TP information for more than 5 seconds the radio automatically tunes into the next station with different Pl but same TP information. If the current station temporarily looses TP information and this stations is set to RETUNE SHORT or RETUNE LONG, then the radio tunes into the next station with same Pl. If no Pl station is found after one tuning cycle, then the radio tunes into the next station with TP information. Note: In TA SEEK mode the current station can be replaced with a different station, since the radio scans for a TP station as soon as field signal or signal strength are weak or the current station has no TP signal (TP has higher priority than PI). This keeps the current station in this mode (PI has higher priority than TP). The beep tones sound if a new station does not broadcast TP information for more than 5 seconds. If the current station temporarily looses TP information the beep tone stops. “PI SEEK” is repressed if a new station has no ANS signal. €¢ MASK: DPI/ALL MASK DPI mode: Marks only AF with different Pl (DPI). Mask ALL mode: Marks all AF with different Pl and no ANS signal with high field strength. [. . . ] press VOLUME (26) to enter number mode. Now press SEL to enter the phone number. Press SEL again to save the number to the phone book. MANUAL ANSWER In auto answer ON mode the display shows “ANSWER? [. . . ]