User manual CLATRONIC BS 1226 NEW

[. . . ] Do not use it outdoors (except if it is designed to be used outdoors). Keep it away from sources of heat, direct sunlight, humidity (never dip it into any liquid) and sharp edges. Do not use the appliance with wet hands. When cleaning or putting it away, switch off the appliance and always pull out the plug from the socket (pull on the plug, not the cable) if the appliance is not being used and remove the attached accessories. [. . . ] To lock it in place, turn the thin section of the suction tube in the direction LOCK until it is clearly heard to lock in place. Set the vacuum power with the vacuum power regulator. Attention: pay attention to the range that can be covered with the cable length. Vacuum power regulator Low vacuum power: Medium vacuum power: High vacuum power: Cable winding device: Pull out the cable up to the maximum length indicated with the yellow mark. Never pull the cable out up to the red mark as the cable winding can be damaged. Said damages are not covered by the warranty. If you wish to use the nozzle attachments, pull the flap on the upper section of the housing. Remove the desired nozzle: Crevice nozzle/Brush nozzle: To vacuum corners and slits "2-in-1" nozzle: When this is folded together (as stored in the compartment) it can be used as a groove nozzle. If you would like to use the brush nozzle, pull the brush section in the direction of the arrow until it locks in place. Smooth floors: Press down the lever with the brush symbol with your foot. Releasing the accessories: Pull them apart while turning slightly. press the button to open the lid of the dust bag compartment. Remove the dust bag holder and pull the dust bag out of the holder. Close the cover so that it snaps into place. Pull the button on the handle (10) upwards in order to open the housing. Clean the engine protection filter after 10 dust bag changes. If necessary, the filter can also be washed in warm water without any additives. â· Place it back into place only once it is completely dry!It is located on the rear part of your appliance behind a ventilation grid. Fit the filter back into place and close the ventilation grid by following the steps above in the opposite order. [. . . ] in such cases please contact our hotline. Broken glass or breakage of plastic parts are always subject to a charge. Defects to consumables or parts subject to wearing (e. Motor pistons, kneading blades, drive shafts, spare remote control, spare toothbrushes, saw blades, etc. [. . . ]