User manual CLATRONIC BS 1229 NEW

[. . . ] Do not use it outdoors (except if it is designed to be used outdoors). Keep it away from sources of heat, direct sunlight, humidity (never dip it into any liquid) and sharp edges. Do not use the appliance with wet hands. When cleaning or putting it away, switch off the appliance and always pull out the plug from the socket (pull on the plug, not the cable) if the appliance is not being used and remove the attached accessories. [. . . ] Attention: pay attention to the range that can be covered with the cable length. Rucksack You can carry the vacuum cleaner conveniently on your back in the rucksack. Please ensure that the lead with the ventilation slit is on the side with the opening in order to avoid overheating. Vacuum power regulator Low vacuum power: Medium vacuum power: High vacuum power: Cable winding device: Pull out the cable up to the maximum length indicated with the yellow mark. Never pull the cable out up to the red mark as the cable winding can be damaged. Said damages are not covered by the warranty. For smooth floors please use the floor nozzle without the attachment. Remove the attachment on the bottom of the floor nozzle by releasing the locking mechanisms and pressing them upwards at the same time. As your vacuum cleaner has a filter which you can remove and wash, there is no need for you to purchase replacement dust backs. Empty the contents of the dust container and clean the main filter by knocking it against an object. â· Stubborn dirt can be removed by passing water against the direction of airflow through the filter fabric. â· Only replace the filter insert when it is completely dry!Clean the motor protection filter approximately every tenth time the vacuum cleaner is emptied. If necessary, the filter can also be washed in warm water without any additives. â· Place it back into place only once it is completely dry!You will find this filter on the right-hand side of your vacuum behind a ventilation grid. Fit the filter back into place and close the ventilation grid by following the steps above in the opposite order. Pull the plug out of the socket before cleaning!Clean the motor protection filter approximately every tenth time the vacuum cleaner is emptied. Clean the filter in hot water without additives. [. . . ] in such cases please contact our hotline. Broken glass or breakage of plastic parts are always subject to a charge. Defects to consumables or parts subject to wearing (e. Motor pistons, kneading blades, drive shafts, spare remote control, spare toothbrushes, saw blades, etc. [. . . ]