User manual CLATRONIC BS 1236 NEW

[. . . ] Do not use it outdoors (except if it is designed to be used outdoors). Keep it away from sources of heat, direct sunlight, humidity (never dip it into any liquid) and sharp edges. Do not use the appliance with wet hands. When cleaning or putting it away, switch off the appliance and always pull out the plug from the socket (pull on the plug, not the cable) if the appliance is not being used and remove the attached accessories. [. . . ] Place your foot on the unlocking button (16) to move the handle into the required position (b or c). Adjust the suction power with the suction power regulator (1). â· Do not allow the machine to remain stationary when switched on!Using the Accessories The accessories should only be replaced when the machine is switched off. Release the suction hose (8) from the hose connection (17). Use the cable take-up to stow away the cable. The traditional dust bag system has been replaced by a transparent dust collection container in which coarse dirt particles and tiny particles floating in the air are swirled out of the suction air by the high speed of the air current. The quantity of dust can be easily read off at any time on the container, which is also very easy to empty. Once the dust level has reached the FULL mark of the dust container, please proceed as follows: 1. Empty the contents of the dust container into a suitable receptacle by pressing button 24 on the dust container. Remove the filter inserts (see illustrations G and H) and clean the filters by tapping and brushing out gently. You can use the cleaning brush (26) to help you. Every third time that the filters are emptied, or in the case of severe soiling, clean the filters by allowing water to flow through them against the direction in which the air blows. The filters should only be re-inserted when they are completely dry!We recommend cleaning these filters every fifth time they are emptied. â· These filters are to be found behind the ventilation grid (4) of the front panel (3). Replacement exhaust filters and motor protection filters can be obtained from our hotline. Pull the plug out of the socket before cleaning!Clean the motor protection filter approximately every 3. Clean the filter in hot water without additives. [. . . ] in such cases please contact our hotline. Broken glass or breakage of plastic parts are always subject to a charge. Defects to consumables or parts subject to wearing (e. Motor pistons, kneading blades, drive shafts, spare remote control, spare toothbrushes, saw blades, etc. [. . . ]