User manual CLATRONIC DB 2709 NEW

[. . . ] Do not use it outdoors (except if it is designed to be used outdoors). Keep it away from sources of heat, direct sunlight, humidity (never dip it into any liquid) and sharp edges. Do not use the appliance with wet hands. When cleaning or putting it away, switch off the appliance and always pull out the plug from the socket (pull on the plug, not the cable) if the appliance is not being used and remove the attached accessories. [. . . ] In case of water with a higher degree of hardness, use distilled water. ATTENTION: Only garments are to be ironed with this device. Electrical connection Make sure that the iron voltage (see name plate) and the line voltage match. Start from the lowest temperature to be set with the thermostat: · As soon as it shuts off, the set temperature is reached (approximately 3 min. Always pull the plug out of the socket after using the iron. Then fill the tank with water and close the filler hole. For this a high temperature is needed (cotton, linen). The quantity of steam can be regulated using the steam quantity regulator (5). Extra steam can be added with the steam jet function (9). Vertical Steam: This can be used to produce a jet of steam in a vertical direction. Fill about half the water tank with water. When the LED shuts off, unplug the device. Now hold the machine horizontally above a sink, turn the steam quantity control to the self-cleaning symbol and rock it to and fro until the tank is empty. Then turn the control back to "0". Place the iron back on the stand and heat it again. To clean the soleplate, pass the iron on a clean cotton cloth. Always remove the mains lead before cleaning!Clean the casing with a slightly damp cloth. [. . . ] in such cases please contact our hotline. Broken glass or breakage of plastic parts are always subject to a charge. Defects to consumables or parts subject to wearing (e. Motor pistons, kneading blades, drive shafts, spare remote control, spare toothbrushes, saw blades, etc. [. . . ]