User manual CLATRONIC DR 2812 NEW

[. . . ] Do not try to repair the appliance on your own. always contact an authorized technician. To avoid the exposure to danger, always have a faulty cable be replaced only by the manufacturer, by our customer service or by a qualified person and with a cable of the same type. Pay careful attention to the following "Special Safety Instructions". [. . . ] Please open the safety lock (4) only when no more steam comes out of the nozzle. Shake any residual water out of the kettle (2). Then fill the measuring beaker (9) and pour the water into the kettle. Attach one of the nozzles to the connecting head of the hose until it locks in place. In order to release the nozzle again please press the button on the connecting head of the hose. Keep the button pressed down and then pull the nozzle off Or extend the nozzle attachments with one or two extension tubes (10). Insert one extension tube into the other until it locks in place and then insert the connected tubes into the handle section (3). Then attach the floor brush nozzle (12) or the accessories. In order to release the extension tube, please press the button on the connecting head. Jet nozzle with round brush attachment (11): Floor brush nozzle (12): Window wiper (13): Non-woven cover (14): For cleaning joints, the edges of bath tubs or areas which are difficult to access etc. for large surfaces , such as laminate or tiles etc. For window cleaning, shower partitions etc. non-woven cover for sensitive surfaces. Please use the cover together with the window wiper. Before inserting the mains lead into the socket, check whether the voltage you intend to use complies with that of the machine. Only connect the machine to a properly installed safety socket, 230 V/50 Hz. After about 3-4 minutes the pressure in the boiler has built up. If there is no more water in the vessel no steam is emitted when the steam switch (5) is pressed. the water has to be filled up as follows: 1. Please turn the device off by moving the on/off switch (1) to "0". Wait for approximately 5 minutes and release the residual pressure with the steam switch!Open the safety lock (4) slowly while pressing down at the same time and wait a few seconds before opening completely after the overpressure has been relieved. [. . . ] Without proof of purchase no free replacement or repair will be carried out. If you wish to make a claim under the guarantee please return the entire machine in the original packaging to your dealer together with the receipt. *) Damage to accessories does not mean automatic free replacement of the whole machine. in such cases please contact our hotline. [. . . ]