User manual CLATRONIC DR 2890 NEW

[. . . ] Do not try to repair the appliance on your own. always contact an authorized technician. To avoid the exposure to danger, always have a faulty cable be replaced only by the manufacturer, by our customer service or by a qualified person and with a cable of the same type. Pay careful attention to the following "Special Safety Instructions". [. . . ] If the pressure in the kettle is still too high, this release device prevents it from being opened. Shake any residual water out of the kettle (2). Fill freshwater from the measuring beaker (9) into the kettle. In order to release the nozzle again, please press the button on the steam pistol. Keep the button pressed down and then pull the nozzle off Or extend the nozzle attachments with one or two extension tubes (10). Please insert the two-parts of the extension tube into one another until they lock into place and then attach them to the steam pistol (3). Then attach the floor brush nozzle (12) or the accessories. In order to release the extension tube, please press the button on the steam pistol. Note: The round brush attachment can only been used in conjunction with the jet nozzle. Jet nozzle with round brush attachment (11): Floor brush nozzle (12): Window wiper (13): Non-woven cover (14): For cleaning joints, the edges of bath tubs or areas which are difficult to access etc. for large surfaces , such as laminate or tiles etc. For window cleaning, shower partitions etc. non-woven cover for sensitive surfaces. Use the cover in conjunction with the floor brush nozzle. Before inserting the mains lead into the socket, check whether the voltage you intend to use complies with that of the machine. After you have filled the kettle with water and selected a cleaning attachment, please proceed as follows: 1. Only connect the machine to a properly installed safety socket, 230 V/50 Hz. If you have not done so already, open the cover on the main device and attach the connection head (17). Use the lock (8) to turn the steam pistol to permanent steam. If there is no more water in the vessel no steam is emitted when the steam switch (5) is pressed. Wait for approximately 5 minutes and release the residual pressure with the steam switch!3 Pull the power plug out of the socket! [. . . ] Without proof of purchase no free replacement or repair will be carried out. If you wish to make a claim under the guarantee please return the entire machine in the original packaging to your dealer together with the receipt. *) Damage to accessories does not mean automatic free replacement of the whole machine. in such cases please contact our hotline. [. . . ]