User manual CLATRONIC DVD 556 NEW

[. . . ] Always place the batteries in the correct direction. Assemble the device in such a way that the available ventilation openings are not covered. Incorrect repairs can constitute a considerable risk for the user. Should the device become damaged, in particular the mains supply cable, do not operate the device any longer, but rather have it repaired by an expert. [. . . ] To avoid damage to the device, no foreign objects must enter the CD tray. note: This DVD receiver supports the copy-protection codes of most DVDs and video CDs. This means that the contents of these CDs can not normally be copied by a video recorder onto tape during normal playback. The volume of the speakers can be manually set for each individual speaker connected to the system. During this procedure it is also possible to adjust the high tones (treble) to your personal taste. The following abbreviations are used for each of the sound channels (speakers). Which speakers can be selected depends on the set LISTENING mod (for TUNER and AUX) or from the contents of the CD. About 2 to 3 seconds after the last entry, the display switches back. By repeatedly pressing »LISTENING« 43 the device switches through the following functions (LISTENING MODE): This only makes sence if all 5 speakers are connected. pRO LOGIC BYPASS: (no display) reproduction is over both front speakers and the subwoofer. Note If only a MONO signal is available then you should always switch to PRO LOGIC BYPASS. With some CDs the machine does not start automatically; please use »MENU/PBC« 32. Note: - During playback of a CD with PBC, the buttons »GO TO« 17, »REPEAT« 25 and the numeric buttons »10« do not function. - If the PBC function is active then you can switch back to the previous menu by pressing »RETURN« 29. In this case, playback of the video CD is stated using » II PLAY/ PAUSE« 3/38. The search speed is set by pressing several times. To continue the playback, keep pressing the corresponding » / « 23 button until PLAY appears of press » II PLAY/PAUSE« 3/38. During playback, freeze frame and search mode functions, you can enlarge (zoom) the picture. Language and subtitles Depending on the DVD inserted, there are often several languages recorded for the sound and the subtitles. - the playback language for the sound can be selected by repeated pressing of »LANGUAGE« Button 16. - the language can be selected for the subtitles by repeatedly pressing »SUBTITLE« button 15. - This does not work for every DVD and must then be set in the menu of the CD. [. . . ] Fault Blank display after switching on No picture Possible cause · Mains cable not plugged in correctly No power at the socket Device not switched on TV set switched off Wrong channel on the TV set DVD player is connected incorrectly or the connection cable is defective CD dirty Note: Light distortion can sometimes arise when there is no mail function. Colour system has been set incorrectly The CD was inserted with the wrong side up. CD dirty CD defective Volume has been set too low or mute function is active. Sound source has been incorrectly selected or not switched on. [. . . ]