User manual CLATRONIC EKI 3157

[. . . ] always contact an authorized technician. To avoid the exposure to danger, always have a faulty cable be replaced only by the manufacturer, by our customer service or by a qualifi ed person and with a cable of the same type. â· Use only original spare parts. â· Pay careful attention to the following "Special Safety Instructions". [. . . ] Then interrupt the operation for at least 30 minutes, otherwise you risk some damages by overload. Weight Charge the cooker ring only with a maximum weight of 4 kg, otherwise you risk damages to the cooking surface. Connected load/wattage The hob can take up an overall load of 1, 800W. Because of this high connected load it is recommended to use a separate connection protected over a 16A safety switch. : Do not use extension cables or multiple sockets as the power consumption of this device is too high for these. Before inserting the mains plug into the socket check whether the voltage which you intend to use corresponds to that of the machine. Only connect the machine to a correctly installed safety socket, 230 V/50 Hz. NOTE: - The lamp POWER (5) goes on and "1800" for the power in watts appears on the display. The food to be cooked is continuously simmering on the power setting which has been selected by you. NOTE: - On the display the power measured in watts will be indicated and the lamp POWER (5) goes on. - After the cooking zone has been switched on the selected power setting can be changed at any time with the keys (4/8). The food to be cooked will be heated up to the temperature selected by you and kept warm on this temperature by automatic regulation. - After the cooking zone has been switched on the pre-selected temperature can be changed at any time with the keys (4/8). With the buttons (4/8) you can set now the desired disconnecting time in hours. â· Wait 3 seconds and then the minute digit appears flashing on the display. â· With the buttons (4/8) you can set now the desired disconnecting time in minutes. â· Wait again 3 seconds and then the residual running time and the selected power level measured in watts appear alternating. NOTE: - After the timer has been switched on you can change the levels with the buttons (4/8) at any time. - Press the button FUNKTION in order to adjust from the cooking function HEATING to the function WARMING. - Interrupt: You can interrupt this process at any time by pressing the ON/OFF button (2). The hob changes back to the standby mode from whatever operating mode. NOTE: The ventilator for the cooling air still continues to run for about 30 seconds. [. . . ] Without proof of purchase no free replacement or repair will be carried out. If you wish to make a claim under the guarantee please return the entire machine in the ori- GB ginal packaging to your dealer together with the receipt. Defects to consumables or parts subject to wearing as well as cleaning, maintenance or the replacement of said parts are not covered by the guarantee and hence are to be paid!After the expiry of the guarantee repairs can be carried by the competent dealer or repair service against the payment of the ensuing costs. [. . . ]