User manual CLATRONIC ES 3643

[. . . ] We hope you will enjoy using the appliance. Symbols in these Instructions for Use Important information for your safety is specially marked. It is essential to comply with these instructions in order to avoid accidents and prevent damage to the machine: WARNING: This warns you of dangers to your health and indicates possible injury risks. CAUTION: This refers to possible hazards to the machine or other objects. [. . . ] CAUTION: Do not brew an espresso when the appliance is still under pressure (for example when milk has been frothed earlier). With too much pressure in the appliance, espresso leaks at the edge of the brewing head. That may lead to a faster wearing of the rubber seal. The status indicator lamp "I" lights up. Use the warming plate to pre-heat your cup(s). If you want to pre-heat the cup(s) more rapidly, rinse Make sure that the drip tray (7) and the drip tray grid (6) are inserted. Fill the water tank with the desired amount of clean, fresh water. The water level must be between the MIN and MAX markings. If you frothed milk earlier, completely release the pressure from the appliance: The switches (9) and (10) must be set to the position "". Turn the steam volume control (3) slowly in the Direction "+" until no steam comes out any longer. Close the steam volume control by turning it in the Place the insert in the filter holder. Ensure that the filter safeguard is not upright. Fill the filter insert with espresso grounds. Observe the MAX marking in the filter insert. Spread the espresso grounds evenly and push down slightly with the tamper (18). Attach the filter holder to the group head. Ensure that the filter holder is properly attached in the group head. The necessary brewing temperature is reached as soon as the indicator lamp "ok" lights up. Place your pre-heated cup(s) under the group head exactly on the two holes you can see in the drip tray grid. The hot water is forced through the filter. Stop the brewing process by turning off the pump when the desired amount of espresso is in your cup(s). NOTE: Remove the filter holder every time after making espresso. [. . . ] Too much coffee grounds in the filter insert. Observe the MAX marking in the filter insert. Coffee grounds residues on the rubber seal of the group head. Switch the appliance off and let it cool down. [. . . ]