User manual CLATRONIC HC 2847 NEW

[. . . ] Do not use it outdoors (except if it is designed to be used outdoors). Keep it away from sources of heat, direct sunlight, humidity (never dip it into any liquid) and sharp edges. Do not use the appliance with wet hands. When cleaning or putting it away, switch off the appliance and always pull out the plug from the socket (pull on the plug, not the cable) if the appliance is not being used and remove the attached accessories. [. . . ] Thick-toothed accessories: to make large waves in hair, for greater hair volume. Fine-toothed accessories: to make small waves in hair Flat accessories: for smooth hair After approximately 5 minutes the device is ready to use. The device must be used only for dry hair. Take a strand of hair and pull it carefully downwards until it is taut. The remaining hair should be put up or fixed in place. Before the halves are pressed together for approx. 5 seconds, we recommend that you ensure that the hair is positioned correctly. Always begin at the base of the hair and move the device in the direction of the hair tip. In order to produce a uniform appearance it is important that the next strands fall in one line. To ensure that the waves are retained for a prolonged period we recommend that you use only a coarse comb or your fingers. Leave the appliance to cool before changing the accessories!Mount the accessories in pairs on the heating surfaces (2 for large hair waves, 2 for small hair waves or 2 for smooth hair) to avoid damaging hair!Leave it cool for a few minutes before putting it away. In order to achieve a pronounced crimping effect, please apply gel or hairspray before using the device (it is possible that the hair will produce a little "steam" or "vapour" - but this is normal). For a loose "permanent wave look" please use thick strands, crimp them with the device for one second and then shake your hair over your head to the front and then to the back again. We do not recommend using the device if your hair is damaged or bleached. Always remove the mains plug before cleaning or servicing the device!Clean the casing with a soft, dry cloth ­ without any additional cleaning agents. Clean the accessories with a slightly moist cloth. If necessary you can use a commercial dish washing detergent. [. . . ] in such cases please contact our hotline. Broken glass or breakage of plastic parts are always subject to a charge. Defects to consumables or parts subject to wearing (e. Motor pistons, kneading blades, drive shafts, spare remote control, spare toothbrushes, saw blades, etc. [. . . ]