User manual CLATRONIC HDR 2941 NEW

[. . . ] Do not try to repair the appliance on your own. always contact an authorized technician. To avoid the exposure to danger, always have a faulty cable be replaced only by the manufacturer, by our customer service or by a qualified person and with a cable of the same type. Pay careful attention to the following "Special Safety Instructions". [. . . ] After filling this is attached to the connection and locked into place by means of a short twist in a clockwise direction. Only connect the machine to a properly installed safety socket, 230 V/50 Hz. Before inserting the mains lead into the socket, check whether the voltage you intend to use complies with that of the machine. Extension Leads Only extension leads that are protected against water spray should be used with high mechanical strength and an internal diameter of at least 3 x 1. The supply hose (not supplied) should have the following dimensions: Length: min 7, 5 m Diameter: min. Clean machines, vehicles, buildings, tools, facades, terraces, garden tools etc. If necessary you can also use detergents. please use detergents sparingly , noting the quantities recommended by the producer. The cleaning of motors/engines and other surfaces that may be covered with oil is only allowed in conjunction with an appropriate oil separator. Do not clean any surfaces that may contain hazardous materials, such as asbestos. If necessary, clean the supply water with a water filter. Any impurities in the water could damage the pump. Switch on the device and allow it to run until the water coming out of the highpressure connection no longer contains any bubbles. Switch off the machine at the main switch (1) and screw the high-pressure hose (7) back on. Allow it to act for a short time without letting the detergent dry. Rinse off the loosened dirt with the high-pressure jet. water Loss It is normal for the pump to lose small quantities of water. If there is a sizeable leak, please contact our service department. Protection against Damage Please do not underestimate the pressure produced by the high-pressure cleaner. If you would like to clean sensitive surfaces it is better to use the fan jet (See , , Adjustment of the Spray Jet" in the section , , Operation"). in the case of paints or insulated facades please begin at a considerable distance away. Move slowly closer - depending on the degree of soiling - to the object to be cleaned. [. . . ] Without proof of purchase no free replacement or repair will be carried out. If you wish to make a claim under the guarantee please return the entire machine in the original packaging to your dealer together with the receipt. *) Damage to accessories does not mean automatic free replacement of the whole machine. in such cases please contact our hotline. [. . . ]