User manual CLATRONIC HMS 2739 OTHER MANUAL

[. . . ] Do not try to repair the appliance on your own. always contact an authorized technician. To avoid the exposure to danger, always have a faulty cable be replaced only by the manufacturer, by our customer service or by a qualified person and with a cable of the same type. Pay careful attention to the following "Special Safety Instructions". [. . . ] When there is no food in the vessel to be mixed. Select a speed using the power level selector switch (3). When you would like to stop mixing, turn the power level selector switch to "0" and unplug the device from the mains. How to use the Kneader hooks/beater 1. Turn the power level selector switch (3) to "0/AUS" and ensure that the mixer (1) has been disconnected from the mains. Press the end of the kneader hooks/beater (10) into the corresponding mixer openings until the hooks click into place. While pressing, turn slightly in order to facilitate the whole operation. Please note that the kneading hook with the curved washer on the shaft can only be inserted on the left-hand side of the mixer when viewed from the bottom. Insert the mains plug into a properly installed 230V/50 Hz safety power socket. The handmixer (1) can be used at various speeds set with the speed regulator (3). In order to release the kneading hook/whisk (10) turn the power level selector switch to "0/AUS" and ensure that the mixer has been disconnected from the mains. How to use the Mixer stand Please check whether the clip (12) of the upper section is locked in place on the back of the mixer. Mount the hooks as described above in the section "How to use the Kneader hooks/beater". In order to place the mixing bowl (8) underneath, pull the clip (6) to unlock the upper section of the mixer stand (5) and fold the mixer upwards. Place the mixer bowl filled with the desired ingredients onto the revolving plate (7). Insert the mains plug into a properly installed 230V/50 Hz safety power socket. The handmixer (1) can be used at various speeds set with the speed regulator (3). When you would like to stop mixing, turn the power level selector switch to "0" and unplug the device from the mains. When you have finished pull the clip (6) again to unlock the upper section of the mixer stand (5) and fold the mixer upwards. Remove the hooks as described above in the section "How to use the Kneader hooks/beater". [. . . ] Without proof of purchase no free replacement or repair will be carried out. If you wish to make a claim under the guarantee please return the entire machine in the original packaging to your dealer together with the receipt. *) Damage to accessories does not mean automatic free replacement of the whole machine. in such cases please contact our hotline. [. . . ]