User manual CLATRONIC HMS 2772 OTHER MANUAL

[. . . ] Do not use it outdoors (except if it is designed to be used outdoors). Keep it away from sources of heat, direct sunlight, humidity (never dip it into any liquid) and sharp edges. Do not use the appliance with wet hands. When cleaning or putting it away, switch off the appliance and always pull out the plug from the socket (pull on the plug, not the cable) if the appliance is not being used and remove the attached accessories. [. . . ] This is for switching to maximum speed for a short time. Do not use this function for more than one minute!Turn the power level selector switch (3) to "0/OFF" and ensure that the mixer (1) has been disconnected from the mains. Press the end of the kneader hooks/beater into the corresponding mixer openings until the hooks click into place. While pressing, turn slightly in order to facilitate the whole operation. Please note that the kneading hook with the curved washer on the shaft can only be inserted on the left-hand side of the mixer when viewed from the bottom. Insert the mains plug into a properly installed 230V/50 Hz safety power socket. The handmixer (1) can be used at various speeds set with the speed regulator (3). In order to release the kneading hook/whisk turn the power level selector switch to "0/OFF" and ensure that the mixer has been disconnected from the mains. How to use the Mixer stand Please check whether this is fixed firmly in place. Mount the hooks as described above in the section "How to use the Kneader hooks/beater". Place the mixer bowl filled with the desired ingredients onto the revolving plate. Insert the mains plug into a properly installed 230V/50 Hz safety power socket. The handmixer (1) can be used at various speeds set with the speed regulator (3). When you would like to stop mixing, turn the power level selector switch to "0" and unplug the device from the mains. When you have finished press the button (6) again to unlock the upper section of the mixer stand (5) and fold the mixer upwards. Remove the hooks as described above in the section "How to use the Kneader hooks/beater". In order to separate the mixer from the upper section (5) of the mixer stand, first lift it by the rear section (cables) and then remove it by pulling upwards. Always choose a utensil and a speed according to the following table: Product/ Max. Before cleaning the equipment, always remove the mains plug from the socket. [. . . ] in such cases please contact our hotline. Broken glass or breakage of plastic parts are always subject to a charge. Defects to consumables or parts subject to wearing (e. Motor pistons, kneading blades, drive shafts, spare remote control, spare toothbrushes, saw blades, etc. [. . . ]