User manual CLATRONIC HPS 2777 OTHER MANUAL

[. . . ] Do not use it outdoors (except if it is designed to be used outdoors). Keep it away from sources of heat, direct sunlight, humidity (never dip it into any liquid) and sharp edges. Do not use the appliance with wet hands. When cleaning or putting it away, switch off the appliance and always pull out the plug from the socket (pull on the plug, not the cable) if the appliance is not being used and remove the attached accessories. [. . . ] You can dry single hair locks by concentrating the flow of hot air with the hairdressing nozzle. Shift the switch on the handle to one of the desired heat/blowing levels: Level 0: off Level 1: medium airflow and medium temperature Level 2: strong airflow and high temperature 5. After use shift the switch to position 0 and pull out the plug. Leave the device to cool before putting it away!COOL-Shot: With this switch it is possible to interrupt the heating process so that the air can be mixed according to individual requirements. Ensure that the round brush is fixed firmly in place. insert the plug into a duly installed 230V/50Hz protective contact socket. When your have dried your hair with a towel (no longer wringing wet), turn it evenly around the round brush or shape your hair with the curler switched on as desired. The curling tongs will put your hair back into shape. In order to unwind a curl, press the button above the operating switch. After use, turn the switch to the "0" position and then remove the mains plug. Allow the device to cool down before storing it away!Remove the cover after turning the cap through approximately 10 degrees against a clockwise direction. Clean the air suction opening from time to time with a fine brush. Clean the housing with a soft, dry cloth without additives. 26 Clean the air suction opening from time to time with a fine brush. Clean the housing with a soft, dry cloth without additives. In order to remove this, take hold of the handle and pull the round brush off. The round brush can be cleaned with a suitable object (comb or brush). Insert the round brush back into the device in the reverse order. [. . . ] Broken glass or breakage of plastic parts are always subject to a charge. Defects to consumables or parts subject to wearing (e. Motor pistons, kneading blades, drive shafts, spare remote control, spare toothbrushes, saw blades, etc. ) as well as cleaning, maintenance or the replacement of said parts are not covered by the guarantee and hence are to be paid! [. . . ]