User manual CLATRONIC HR 2603 N 2

[. . . ] Do not use it outdoors (except if it is designed to be used outdoors). Keep it away from sources of heat, direct sunlight, humidity (never dip it into any liquid) and sharp edges. Do not use the appliance with wet hands. [. . . ] Leave the shaver to charge for at least 16 hours before using for the first time. It takes from 14 to 16 hours for a flat battery to be charged. Take the protection cap off the device before use. shift the on/off switch up (towards the shearing head) to switch on the device. Use the trimmer on the back of the device to cut long hair. Push the release button upwards until the trimmer comes off. Run the shearing blade across the surface to be cut with the blade lying flat against it to remove the remaining hair. After use switch the device off with the on/off switch and push the release button in until the trimmer fits back into place. Should the incorporated accumulator be flat, the razor can be used anyway by connecting the mains cable. Switch the device off with the on/off switch and pull out the plug. press the release button to remove the blade. Clean the razor with the supplied cleaning brush. Attention: do not touch the blades of the razor with your fingers!In order to remove hair in the gaps of the blade, use the supplied brush. Put the shearing blade back on after cleaning. This device has been tested according to all relevant current CE guidelines, such as electromagnetic compatibility and low voltage directives, and has been constructed in accordance with the latest safety regulations. [. . . ] Broken glass or breakage of plastic parts are always subject to a charge. Defects to consumables or parts subject to wearing (e. Motor pistons, kneading blades, drive shafts, spare remote control, spare toothbrushes, saw blades, etc. [. . . ]