User manual CLATRONIC HSM 2686 OTHER MANUAL

[. . . ] Do not use it outdoors (except if it is designed to be used outdoors). Keep it away from sources of heat, direct sunlight, humidity (never dip it into any liquid) and sharp edges. Do not use the appliance with wet hands. [. . . ] Fine Adjustment of the Voltage (Mains operated Machines) In case of voltage fluctuations in the mains it may be necessary to adjust the machine. Turn the voltage adjustment screw (6) with a screwdriver or small coin so that the machine runs as quietly as possible. The device can now also be used when the batteries are flat. Charging the Battery Before the machine can be used without a cord, the battery must be charged. The first time charging will take approx. If you are not sure of the cutting length, start from 12 mm. Insert the plug in a duly installed 230V/50Hz protective contact socket, switch on the device and run the device with the guide comb upwards and at a constant speed through your hair. For areas which are not accessible to the razor it is possible to use the scissors. IMPORTANT: Do not use the device for more than 10 minutes. Allow the equipment to cool down for 10 minutes, before using it again. Clean the device after use with a dry cloth. The blades and accessories should be cleaned with the brush. This device has been tested according to all relevant current CE guidelines, such as electromagnetic compatibility and low voltage directives, and has been constructed in accordance with the latest safety regulations. Subject to technical changes without prior notice! [. . . ] Broken glass or breakage of plastic parts are always subject to a charge. Defects to consumables or parts subject to wearing (e. Motor pistons, kneading blades, drive shafts, spare remote control, spare toothbrushes, saw blades, etc. [. . . ]