User manual CLATRONIC HSMR 2757 OTHER MANUAL

[. . . ] Do not use it outdoors (except if it is designed to be used outdoors). Keep it away from sources of heat, direct sunlight, humidity (never dip it into any liquid) and sharp edges. Do not use the appliance with wet hands. When cleaning or putting it away, switch off the appliance and always pull out the plug from the socket (pull on the plug, not the cable) if the appliance is not being used and remove the attached accessories. [. . . ] NEVER use any adapter other than that supplied with the machine. Battery operation You can use your hair and beard cutting machine with the battery once this has been charged up. The device is partly charged when it leaves the factory. Please charge the device for a period of 12 hours before using it for the first time. To charge up the device, insert the plug of the power pack into a 230 V/50 Hz socket and then connect the cable with the connection socket (5) of the charging station (6) or directly with the device. After this time it must be switched off and allowed to cool down for 10 minutes. The charging LED lights up during the charging procedure. Useful tips regarding battery life Battery life can be lengthened by paying attention to the following instructions: · Wait until the battery is almost completely flat before recharging. ⷠNever leave the machine connected to the charger for more than 24 hours. ⷠCharge the machine only with room temperature between 0 and +40°C. beard trimming and cutting Shift the selector (2) to the I position. Start with the longest cutting level and trim your beard gradually to the desired length. Note: Lock the desired cutting length (cutting length comb) into place with the function ring (7). Released: locked: thinning function: It is now possible to adjust the cutting length comb Now you can cut your hair or beard with the length of the cutting length comb that has been set The further you turn the function ring in the direction of the thinning symbol, the fewer hairs are thinned out. Hair cutting Shift the selector (2) to the I position: Start with the longest cutting level and shorten the hair gradually to the desired length. Note: Lock the desired cutting length (cutting length comb) into place with the function ring (7). The shearing head enables the precise trimming of the beard contours even areas, which are difficult to reach, and a clean shaving of the hairline in the neck area. Use only a slightly damp and soft cloth to clean the machine. ⷠAfter use remove each time all hair left on the machine with the supplied brush. ⷠRemove the cutting comb and the cutting head to either blow off the hair particles or brush them off with the cleaning brush. [. . . ] in such cases please contact our hotline. Broken glass or breakage of plastic parts are always subject to a charge. Defects to consumables or parts subject to wearing (e. Motor pistons, kneading blades, drive shafts, spare remote control, spare toothbrushes, saw blades, etc. [. . . ]