User manual CLATRONIC KA 2823 DS 2

[. . . ] Do not use it outdoors (except if it is designed to be used outdoors). Keep it away from sources of heat, direct sunlight, humidity (never dip it into any liquid) and sharp edges. Do not use the appliance with wet hands. [. . . ] Then mount the device again by proceeding in the opposite order. Carry out 2 or 3 cycles with cold water only to clean the device before brewing the first cup of coffee. Any smoke or smells produced during this procedure are normal. The details can be found on the appliance's nameplate. Now fill with enough fresh cold water for the desired number of cups. You can read the level on the water level display. Place a paper filter (size 1x4) carefully into the filter funnel and fill it with coffee powder (approx. Lock in the filter until it snaps into place. Your appliance is provided with a drip stop. By removing the pot, before the water runs through the filter completely, it avoids that the coffee drips on the base. If there is still water in the tank or filter, make sure that the pot is placed back under the filter to avoid overflowing. When no more coffee is running into the pot it can be removed. If you would like to keep the remaining coffee warm, the switch must remain in the , , EIN/1" position. The hot plate will keep the coffee warm until you switch the machine , , AUS/0". Always pull he plug before cleaning and wait for the appliance to cool down. Clean the outside of the appliance, if necessary, with a slightly moist cloth without any detergent. The filter holder can be washed as usual in warm washing up water. You can clean the inside with warm water. [. . . ] Broken glass or breakage of plastic parts are always subject to a charge. Defects to consumables or parts subject to wearing (e. Motor pistons, kneading blades, drive shafts, spare remote control, spare toothbrushes, saw blades, etc. [. . . ]