User manual CLATRONIC KA 2888 OTHER MANUAL

[. . . ] Do not use it outdoors (except if it is designed to be used outdoors). Keep it away from sources of heat, direct sunlight, humidity (never dip it into any liquid) and sharp edges. Do not use the appliance with wet hands. When cleaning or putting it away, switch off the appliance and always pull out the plug from the socket (pull on the plug, not the cable) if the appliance is not being used and remove the attached accessories. [. . . ] Only connect the machine to a properly installed safety socket, 230 V/50 Hz. In order to leave the adjustment mode press the TIMER button twice or wait for 10 seconds. Fill the machine to the level corresponding to the number of cups required with cold water. Insert a paper filter (size 1x4) in the filter funnel and fill with ground coffee (approx. Lock in the filter until it snaps into place. Your appliance is provided with a drip stop. By removing the pot, before the water runs through the filter completely, it avoids that the coffee drips on the base. If there is still water in the tank or filter, make sure that the pot is placed back under the filter to avoid overflowing. Switching on the coffee machine directly: Please follow the instructions under points 1-5 "Initial Operation". B) The unit switches itself off automatically about two hours after the brewing. C) The unit is switched off when both LEDs are off. If you wish to switch the unit off manually or to deactivate the timer, press the START button repeatedly until both LEDs go out. In order to leave the adjustment mode press the TIMER button once or wait for 10 seconds. d) If you have programmed the device , press the START button twice. The green LED lights up next to AUTO (automatic). The device switches itself on at the set time (the red light is on). If you wish to switch the unit off manually or to deactivate the timer, press the START button repeatedly until both LEDs go out. Descaling is necessary when the time needed to prepare coffee becomes considerably longer. Only commercially available descaling products based on citric acid should be used. Before cleaning the machine you should always remove the mains lead and wait until the machine has cooled down. [. . . ] in such cases please contact our hotline. Broken glass or breakage of plastic parts are always subject to a charge. Defects to consumables or parts subject to wearing (e. Motor pistons, kneading blades, drive shafts, spare remote control, spare toothbrushes, saw blades, etc. [. . . ]