User manual CLATRONIC KA-V2903 OTHER MANUAL

[. . . ] Keep it away from sources of heat, direct sunlight, humidity (never dip it into any liquid) and sharp edges. Do not use the appliance with wet hands. When cleaning or putting it away, switch off the appliance and always pull out the plug from the socket (pull on the plug, not the cable) if the appliance is not being used and remove the attached accessories. Do not operate the machine without supervision. [. . . ] When the MENU/OK/MEMORY button is flashing you can make some coffee. If you would like to program presets you must change to the programming mode. You can set the following presets, filling quantity, pre-injection, percolation time and percolation temperature. There are two ways to select the following menu item and change the presets: One-Time Preset: If you want to change the presets only for the next percolation process, but do not wish to store them, please proceed as follows: · Keep the MENU/OK/ MEMORY button pressed down for five seconds. in the display the "normal cup" and "M" flash. / BACK button once you Note: By pressing the reach the programming mode of the presets for the "large cup" (the symbols "large cup" and "M" flash in the display). Place a cup under the coffee spout (13). Button Stop the percolation process with the when the desired filling quantity has been reached. The preset filling quantity is 100 ml when the saved or the one-time selected setting is used. Coffee Quantity You can make your coffee with a small, normal or large quantity of coffee. the "normal" setting is shown in the display by 2 arrowheads in the middle. Save the changes with the MENU/OK/MEMORY button. Before cleaning the machine please wait until it has cooled down. Never immerse the machine in water or other liquids. Do not clean any of the machine parts in the dishwasher. The machine parts should always be dried by hand and never placed in a cooker or microwave oven to dry. Tilt the coffee spout towards the machine (B). Then remove the coffee spout by pulling it downwards (C). Rinse out the coffee spout with hot water. Otherwise the coffee spout is not correctly attached. Cleaning the Brew Group Before cleaning the device switch it to the , , O" position and then remove the mains plug (19) from the socket. If the machine is used daily the brew group must be cleaned regularly, i. [. . . ] Coffee grounds Insert the coffee collector (8) is grounds collector not correctly correctly. Insert the brew The brew group group correctly (see is not correctly section , , Position of inserted. Switch off the device and fill up the container (2). In the coffee preparation cycle the noise The coffee beans of the grinding are used up. [. . . ]