User manual CLATRONIC LS 2755 NEW

[. . . ] Keep it away from sources of heat, direct sunlight, humidity (never dip it into any liquid) and sharp edges. Do not use the appliance with wet hands. if the appliance is humid or wet , unplug it immediately. When cleaning or putting it away, switch off the appliance and always pull out the plug from the socket (pull on the plug, not the cable) if the appliance is not being used and remove the attached accessories. [. . . ] You should not use any extension or replace the hose with another one, as this may result in malfunctions. The air must be allowed to flow freely out of the device, as any blockage may cause it to overheat. Close the windows and doors so that no air can enter the room from outside. The device will then work more effectively. â· Please ensure that the air can be drawn in and can flow out unhindered. Remove any mobile sources of heat from the room if necessary. Please ensure that the polarity is correct (see the floor of the battery compartment or the inscription on the outside)!If the remote control is not used for a prolonged period, remove the batteries in order to prevent battery acid leaking. Different battery types or new and used batteries must not be used together. Never throw batteries into a fire or immerse in water. When inserting a battery, ensure the correct polarity. In order to release the hose again, press in the right-hand retainer and push the hose to the right out of the holder. The mains lead should only be pulled as far as the stop. Under no circumstances should you pull the lead any further with force, as this may damage the device. Only connect the machine to a properly installed safety socket, 230 V/50 Hz. Make sure that the degree of protection of the socket to which the device is connected is of at least 10 ampere! place the device on any heat-resistant flat surface. Ensure that air can enter and leave unhindered. The distance from the air inlet grille (5/7) to the nearest wall should be at least 20 cm. The distance from the air outlet grille (2) to the nearest wall should be more than 1m. Turn the device on with the , , " button (J/13). The length of time is increased with every press of the button by 1 hour (00, 01, 02. [. . . ] Dehumidifying When the device is operated in the , , dehumidify" mode you should allow the exhaust air to flow back into the room. During dehumidification only the low ventilator speed is possible (, , " control lamp lights up in orange). In this mode of operation it may be necessary to empty the condensation container more frequently (see section on , , Emptying the Water Container"). The movement is stopped by repeatedly pressing the , , " button and the air slit remains in this position. [. . . ]