User manual CLATRONIC MC 1002 CD NEW

[. . . ] If the device is not used for a longer period, remove the plug connector from the plug socket or take out the batteries. These symbols may be found on the machine and are intended to indicate the following: The lightning symbol should advise the user of parts in the inside of the device which carry dangerously high voltage levels. The symbol with an exclamation mark should advise the user of important operation or maintenance instructions in the accompanying documentation. Devices bearing this symbol work with a , , class 1 laser" for tracing the CD. [. . . ] mUTE (3 on device or 11 on the remote control): it is used to zero rapidly the volume. To remove this function, press the MUTE key again. Switch the music centre to standby using the POWER button (19, or 2 on the remote control). Press the I / I button (5/10, or 7 on the remote control) until the correct hour is reached. When this button is pressed once, the display increases by only one number. When this button is held down, fast search is started. In order to set the minutes, proceed as before under point 4. Press the MEMORY/CLOCK button (8 on the remote control) when you are ready to store your settings. Please note that the display only flashes for a few seconds in each case. If the adjustment is interrupted and the display stopped flashing, adjustment of the time has to be started again from the beginning. Note: If the entire time display is flashing, the stored time has been lost, possibly as a result of a power cut, and has to be set again. Use the SKIP/SEARCH buttons, I = forwards (10) and I = reverse (5) to tune into the desired radio station. if the appropriate button is pressed down for approx. If reception is too weak and there is interference on the station being received, try to improve reception by turning, bending and altering the length of the aerial. In this frequency band all programmes are transmitted only in "mono". To save a selected radio station, press first the PROG/MEMORY key (6). MEMORY flashes on the display and CH appears with 00 below it. Now select the desired storage location using the M-UP/REPEAT button (9). it is possible to store up to 40 stations (20 stations per band). To recall a saved radio station, press the M-UP/REPEAT key (9 on the device and on the remote control). Insert an audio CD with the printed side facing upwards onto the central cone until the CD locks into place. Press the OPEN/CLOSE button (14) again to close the CD compartment. [. . . ] In this case, only the faulty accessory will be sent in or ordered with the agreement of our customer service!Damages to glass parts are not free of charge!Defects to consumables or parts subject to wearing (e. Motor pistons, kneading blades, drive shafts, spare remote control, spare toothbrushes, saw blades, etc. [. . . ]