User manual CLATRONIC RA 2904 NEW

[. . . ] Do not try to repair the appliance on your own. always contact an authorized technician. To avoid the exposure to danger, always have a faulty cable be replaced only by the manufacturer, by our customer service or by a qualified person and with a cable of the same type. Pay careful attention to the following "Special Safety Instructions". [. . . ] Ensure that a safety distance is maintained between the power cord and the housing. In order to avoid overheating it is important that the air inlets and outlets are kept clear. Never suspend objects in front of or above the radiator. do not use the radiator in the open air. This radiator is not suitable for use in bathrooms, washing rooms or rooms which are used in a similar manner. The radiator must never be placed in a position where it could fall into a bathtub or other water container. The radiator should not be placed directly below a mains power socket. The radiator should only be used in an upright position. If the radiator should fall over, first remove the plug from the socket and allow the radiator to cool down before returning it to an upright position. Before the radiator is used, the rollers must be attached. to do so , place the radiator upside-down (hold the underside facing upwards); avoid hard surfaces. Attach the castors between the first and second, and between the second-before-last and the last fin in the correct position. Pass the U-shaped clamps through the holes of each roller carrier and then tighten the wing nuts. Only connect the machine to a properly installed safety socket, 230 V/50 Hz. The POWER indicator light signals that the device is ready for operation. Operational switch I alone is on: Operational switch II alone is on: Operational switches I + II are on: Operational switch set to 0: = low power = medium power = high power Radiator is off. In order to find the ideal thermostat setting, turn the thermostat control clockwise to , , HIGH". As soon as the desired temperature has been reached turn the thermostat control slowly counter-clockwise until the radiator switches off and the indicator light of the switch goes out. The radiator will now automatically stay at the desired temperature. Always remove the power cable from the socket and allow the radiator to cool down before cleaning it. [. . . ] Without proof of purchase no free replacement or repair will be carried out. If you wish to make a claim under the guarantee please return the entire machine in the original packaging to your dealer together with the receipt. *) Damage to accessories does not mean automatic free replacement of the whole machine. in such cases please contact our hotline. [. . . ]