User manual CLATRONIC RB 2768 NEW

[. . . ] Do not use it outdoors (except if it is designed to be used outdoors). Keep it away from sources of heat, direct sunlight, humidity (never dip it into any liquid) and sharp edges. Do not use the appliance with wet hands. [. . . ] Let the iron cool down completely before you pack it away. When handing the travel iron over to other people please consign also the use instructions. Clean the iron with a slightly moist cloth. Press the unlock button (4) and pull the handle up until it locks in place Fill the water tank (2) through the filler aperture (1) with pure water (up to degree of hardness 2). If the water is harder than this, please use distilled water. Fill the iron with the help of the filling beaker. Before initial use of the iron press the steam jet button (9) to allow the contents of the water tank to evaporate on level · ATTENTION: iron only garments with this appliance. The voltage can be switched between 220-240 V/100-127 V using the voltage switch (7) on the bottom of the iron. Sort out the garments according to their ironing temperatures. Insert the mains plug into a correctly installed safety socket. As soon as it shuts off, the set temperature is reached (approximately 3 min. Always pull the plug out of the socket after using the iron. In order to moisten an area to be ironed, press the spray button (3). Please do not wind it around the device. Always remove the mains lead before cleaning!Clean the casing with a slightly damp cloth. Clean the iron with a slightly moist cloth. Please do not use any abrasive cleaning agents! [. . . ] Broken glass or breakage of plastic parts are always subject to a charge. Defects to consumables or parts subject to wearing (e. Motor pistons, kneading blades, drive shafts, spare remote control, spare toothbrushes, saw blades, etc. [. . . ]