User manual CLATRONIC SLS 618 NEW

[. . . ] For safety reasons a broken or damaged mains lead may only be replaced by an equivalent lead from the manufacturer, our customer service department or a similary qualified person. If the device is not used for a longer period, remove the plug connector from the plug socket or take out the batteries. These symbols may be found on the machine and are intended to indicate the following: The lightning symbol should advise the user of parts in the inside of the device which carry dangerously high voltage levels. The symbol with an exclamation mark should advise the user of important operation or maintenance instructions in the accompanying documentation. [. . . ] Attach the loudspeaker holder (bracket) to the upper end of the foot and insert the loudspeaker into the mounting. The cinch plug of the loudspeaker cable is now connected to the AUDIO OUTPUT of the subwoofer according to the loudspeakers. Bad connections may lead to poor sound quality. AUDIO OUTPUT: Outputs on the right and left for connection of the front loudspeakers (R Front right, L Front left). Output for connection of the centre loudspeaker (CEN Centre) output for connection of the surround loudspeakers on the right and left (RS Surround right speaker, LS Surround left speaker) Mains lead Correct connection is as follows: When you have connected all loudspeakers and devices as described you can insert the mains plug of the subwoofer into a correctly installed 230 volt, 50 hertz power socket. Please ensure that the polarity is correct (see the floor of the battery compartment or the inscription on the outside)!If the remote control is not used for a prolonged period, remove the batteries in order to prevent battery acid leaking. Always replace the complete set of batteries. Warning: batteries are not to be disposed of together with domestic wastes. Dispose of the used batteries at the relevant collection bin or at your dealer's. When the remote control is used, care should be taken that there are no objects between the remote control and the central loudspeaker. These objects prevent the infrared beam of the remote control from reaching the receiver of the central loudspeaker. It is then not possible to control the television with the remote control. CENTER +/-: With these buttons you can set the volume of the centre loudspeaker. BASS (SUBWOOFER) +/-: With these buttons you can set the volume of the subwoofer. SUR (SURROUND) +/-: With these buttons you can set the volume of the surround loudspeakers. mASTER +/-: Buttons for volume adjustment. MUTE: With this button you can switch off the loudspeakers without changing the volume. NOTE: When switching off this function ensure that the overall volume is not set to maximum! Note: Some buttons are located both on the front panel of the device and on the remote control. [. . . ] For repairs or replacement during the life of the guarantee return the device in its original packing together with the proof of purchase to your dealer. *) Damage to accessories does not mean automatic free replacement of the whole machine. in such cases please contact our hotline. Broken glass or breakage of plastic parts are always subject to a charge. [. . . ]