User manual CLATRONIC SRR 510 CD NEW

[. . . ] If the device is not used for a longer period, remove the plug connector from the plug socket or take out the batteries. These symbols may be found on the machine and are intended to indicate the following: The lightning symbol should advise the user of parts in the inside of the device which carry dangerously high voltage levels. The symbol with an exclamation mark should advise the user of important operation or maintenance instructions in the accompanying documentation. Devices bearing this symbol work with a , , class 1 laser" for tracing the CD. [. . . ] The desired frequency band can be selected with the BAND selector (4). In USW/FM mode pull out the telescopic antenna (1) and turn it to improve reception. In order to switch off the radio, turn the function selector (15) to TAPE. Insert a recorded audio cassette with the tape facing upwards and the side you wish to listen to facing the back into the compartment (full reel on the right). Press the play button (20) in order to listen to the tape. Press it again when you wish to continue listening. If necessary, fast wind the tape with the = forwards; = reverse). Backwards ( Always press the stop/eject button / (17) before switching to another function or when stopping the tape. When the stop/eject button (17) is pressed again, the door of the cassette compartment opens. Insert an audiocassette with the side to be played facing out (full reel on the right). Make sure that both erase protection tabs on the cassette are not broken off; otherwise recording is not possible. Select the recording source with the FUNCTION key (15). The recording can be briefly stopped with the Pause key (16) or stopped completely with the Stop/Eject key (17). Insert a CD with the printed side facing up and close the CD deck. After a few seconds the display shows the total number of tracks on the CD. Press the Play/Pause key to play the CD. The CD starts to play from the first track. With the SKIP/SEARCH keys you skip forward or backward from one track to another by pressing the relevant key briefly. By keeping the key pressed, you can search through the track (B. PLAY/PAUSE When a CD is playing, pressing once = pause (the information in the display flashes). if the PLAY/PAUSE button is pressed a second time playback continues. REPEAT Press once (the dot on the display flashes): the current track is repeated continuously. [. . . ] *) Accessories are subject to the legally envisaged warranty obligation (6 months) and do not entitle to the free replacement of the entire device. In this case, only the faulty accessory will be sent in or ordered with the agreement of our customer service!Damages to glass parts are not free of charge!Defects to consumables or parts subject to wearing (e. [. . . ]