User manual CLATRONIC UM 2859 NEW

[. . . ] Do not use it outdoors (except if it is designed to be used outdoors). Keep it away from sources of heat, direct sunlight, humidity (never dip it into any liquid) and sharp edges. Do not use the appliance with wet hands. When cleaning or putting it away, switch off the appliance and always pull out the plug from the socket (pull on the plug, not the cable) if the appliance is not being used and remove the attached accessories. [. . . ] Never pour liquids hotter than 60°C into the jug!Do not put hard foods such as ice cubes, nutmeg or large pieces of chocolate into the container!Do not operate the device for more than three minutes. Then allow it to cool down for approx 3 minutes before using it again. Turn the mixing bowl in a clockwise direction until it locks into place. The b point on the mixing bowl is now positioned above the arrow on the motor housing. The device only functions when the mixing bowl and the large lid of the mixing bowl are in place and have been correctly tightened. Cut the food to be mixed into small pieces. Now place the ingredients to be mixed in the mixing vessel and close the lid. The fixtures on the edge of the underside of the lid and on the top edge of the container must grip into one another. Then seal the lid by turning the filler lid in a clockwise direction. The decanter must be held firmly during the mixing. Level 1 = low rpm Level 6 = high rpm To switch the device off, turn the switch back to the "0" position. In order to insert more food to be mixed the small lid may be removed. Please switch off the machine before doing so. Keep the button pressed down in this position according to the desired interval length. In order to remove the mixer jug turn it counterclockwise. Fill half of the jug with water and press the push button for approximately 10 seconds. In order to clean the mixer properly disassemble the appliance as follows: Turn the mixing bowl in an anticlockwise direction and remove it from the motor housing. Difficult-to-remove items in the mixing bowl can be removed with a rinsing brush. [. . . ] in such cases please contact our hotline. Broken glass or breakage of plastic parts are always subject to a charge. Defects to consumables or parts subject to wearing (e. Motor pistons, kneading blades, drive shafts, spare remote control, spare toothbrushes, saw blades, etc. [. . . ]