User manual CLATRONIC UM 2963 PC 2

[. . . ] Do not use it outdoors (except if it is designed to be used outdoors). Keep it away from sources of heat, direct sunlight, humidity (never dip it into any liquid) and sharp edges. Do not use the appliance with wet hands. When cleaning or putting it away, switch off the appliance and always pull out the plug from the socket (pull on the plug, not the cable) if the appliance is not being used and remove the attached accessories. [. . . ] Ensure that the rotary switch (10) is in the , , 0" position and that the mains lead is not in the socket. The screw top (7), the knife block (6), sealing ring (5) and the safety ring (4) have to be installed in the correct order (from 7 to 4), see , , Overview of Components". Please ensure that the closed side of the safety ring (4) is facing the carafe and that the screw top is tightly closed. Do not forget to insert the sealing ring as otherwise the carafe will leak. The carafe must be positioned in such a way that the safety ring is in contact with the safety switch (8). Connect the mains lead to a properly installed 230 V, 50 Hz safety power socket. Cut the food to be mixed into small pieces. For constant mixing (continuous mode): When operating in levels 1 or 2 snap the selector into the desired position: Level 1 = low rpm Level 2 = high rpm Shift the selector to , , 0" to switch off the appliance. Turn the switch now to position , , M". The switch must be kept in this position for the desired interval. Short-term operation: 1 Minute IMPORTANT NOTE Citrus juices and food containing acids should never be stored in metal vessels. Please only fill the carafe up to 1/3 full with ice cubes. Wash and dry all the parts of the decanter. Warning: The electric plug must be removed before the mixer is taken apart!The lids, carafe, safety ring and screw top can be placed in the dishwasher for cleaning. The knife block and sealing ring should only be briefly rinsed off with hot water (Caution: Beware of injury!After cleaning and drying the decanter must be reassembled so that the gasket is located between the blade block and the decanter. See , , Overview of Components" Before using each time the blade block must be screwed securely onto the decanter. Dry the external surface of the mixer base with a moist cloth. Important notice on the safety switch The all-purpose mixer is equipped with a safety switch that avoids that the motor run without the decanter mounted on it (danger of injury! [. . . ] in such cases please contact our hotline. Broken glass or breakage of plastic parts are always subject to a charge. Defects to consumables or parts subject to wearing (e. Motor pistons, kneading blades, drive shafts, spare remote control, spare toothbrushes, saw blades, etc. [. . . ]