User manual CLICKER CLK1

[. . . ] Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Determine your brand from an original hand held remote or locate the motor unit receiver. The receiver can be mounted on the back or side panel of the motor unit or could be mounted on the ceiling or wall. If your system has code switches they can be found in an original hand held remote or on the motor unit receiver. [. . . ] Exception: If your original hand held remote has 3 buttons and you are using the small button on left, place a 1; center button, place a 2; large button place a 3 in box 1 in the table above. Boxes 2 through 9, place number that corresponds with switch position. choose a 4-digit Personal Identification Number (PIN). Any combination of numbers from 0 to 9 may be used. Write PIN here: Before initial programming, press and # together until keypad stops flashing. This erases previous programming and returns unit to unprogrammed factory setting. When programming to more than one door, do not clear keyless after a successful programming of the first door. Enter code in sequence from the TABLE above and the # key. To test, enter PIN followed by any 5th additional number. Note: Do not use the star or # pound keys as a 5th number. If programming is unsuccessful, Check to be sure the code from TABLE above match's switch positions from your system. If you did not have any remotes and you set a 9 digit random code and you have a yellow, white or gray smart-learn button, press the smart-learn button and release it. Enter your 4-digit pin number and hold any additional number, the door should operate. Locate your systems code switch positions from an original hand held remote or the motor unit receiver. Locate your smart-learn button on your system. It will be located on the side or back panel of the motor unit (near the small grey wire antenna). Any combination of numbers from 0 to 9 may be used. Write PIN here: Before initial programming, press and # together until keypad stops flashing. This erases previous programming and returns unit to unprogrammed factory setting. When programming to more than one door, do not clear keyless after a successful programming of the first door. Any combination of numbers from 0 to 9 may be used. Write PIN here: Before initial programming, press and # together until keypad stops flashing. [. . . ] When programming to more than one door, do not clear keyless after a successful programming of the first door. Step 5 Enter code in sequence from the TABLE above and the # key. To test enter PIN followed by any 5th additional number. Note: Do not use the star or # pound keys as a 5th number. [. . . ]