User manual CLIFFORD 38

[. . . ] (See "Programming Table for Remote Controls" on page 9. ) þ Electronic Scan Prevention (ESP) -- Some thieves use digital code "scanners" that rapidly transmit one remote control code after another until they hit the one code that activates the unlock function of a keyless entry system. Electronic Scan Prevention recognizes scanners and blocks their codes to prevent unlocking by anyone but you. þ Remote Panic with Safety LocksTM (optional) -- In a threatening situation, you can activate a siren/horn, flash the parking lights and unlock the doors for immediate entry into your vehicle. (Requires the addition of an optional siren or interfacing with the vehicle horn. ) þ Audible Lock/Unlock Confirmation Capability --This programmable feature will chirp the siren or beep the horn two times when the LOCK button is pressed and once when the UNLOCK button is pressed. (Requires the addition of an optional siren or interface with the vehicle horn). þ Visual Confirmations --The AMX38 will flash your vehicle's parking lights to confirm door locking and unlocking. þ Interior Light Illumination --Turns on the interior lights for 30 seconds when you remotely unlock or until the ignition key is turned "ON. " þ User-Programmable Illuminated Exit --The system can be programmed to turn on the interior lights for 30 seconds after the ignition key has been turned "OFF. " þ Remote-Controlled Door Lock/Unlock -- Allows you to lock and unlock your doors without using your key. þ Two-Stage Unlock Capability -- For personal safety, when you press the remote control UNLOCK button, only the driver's door will unlock. [. . . ] Two-Stage Unlock If the optional two stage unlock feature was installed, press the UNLOCK button for 1-2 seconds. Within 3 seconds, press the UNLOCK button again and the passenger doors will unlock. User-Programmable Ignition-Controlled Door Lock/Unlock For the ultimate in security and convenience, the AMX38 will automatically lock the doors when the ignition key is turned "ON" or the engine is started, and the doors will unlock when the ignition key is turned "OFF. " This feature can be programmed ON or OFF. (See "Programming Table for System Features" on page 8. ) 4 AMX38 Owner's Manual Rev. A - 0499 User-Programmable Passive Starter Disable If the optional starter disable relay was added, your system can be programmed to automatically disable the starter 30 seconds after the ignition key is turned "OFF. " (See "Programming Table for System Features" on page 8. ) 1. Turn the ignition key to the "OFF" position. The LED will flash rapidly for 30 seconds. The LED will then flash slowly to indicate the starter has been disabled. User-Programmable Passive Door Lock If the Passive Starter Disable and Passive Lock features are programmed "ON, " the system will automatically disable the starter (optional) and lock the doors 30 seconds after the ignition key is turned "OFF. " (See "Programming Table for System Features" on page 8. ) 1. Turn the ignition key to the "OFF" position and remove the key. The LED will flash rapidly for 30 seconds. The doors will lock and the LED will flash slowly to indicate the starter has been disabled. Remote Panic with Safety LocksTM (optional) In a threatening situation, you can activate Remote Panic with Safety LocksTM. When activated, the siren/horn will sound and the parking lights will flash. If you are inside your vehicle and the ignition key is "ON, " the doors will lock. If you are outside the vehicle with the ignition key "OFF, " the doors will unlock allowing you to move to safety. (Requires the addition of a siren or interfacing with your vehicle horn. ) Activate 1. Press the remote control LOCK button for 3-4 seconds. The siren/horn will sound and the parking lights will flash on and off. If the ignition key is "OFF, " the doors will unlock. If the ignition key is "ON, " the doors will lock. Press the remote control LOCK button for 1-2 seconds. [. . . ] Flick the valet switch to the "OFF" position. The LED will turn off to indicate the system is no longer in Protected Valet Mode. Turn the ignition key to the "OFF" position. LED Off On solid Slow flash Rapid flash Status System is disarmed In Protected Valet Mode System is armed Passive arming 7 AMX38 Owner's Manual Rev. A - 0499 User-Programmable Features All system and remote control programmable features are accomplished by turning the ignition key "ON" (or starting the engine) and flicking the valet switch on and off a preset number of times. [. . . ]