User manual CLIFFORD 60

[. . . ] World-Class Auto Security TM concept 60 Owner's Manual Table of Contents Standard Features of the Concept 6O . Built-in vehicle recovery/anti-carjacking circuitry Definitions Your secret disarming code 3 8 9 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 . 10 IMPORTANT: What you MUST do to drive your car What you MUST do if the system reminds you to enter your code How to set your own secret disarming code . 11 What to do in a carjacking situation . [. . . ] In contrast, Concept Series systems use complex digital signal processing and unbreachable encryption to randomly change the digital code every time you use the remote control. Your remote will never transmit the same code twice, and the control unit will never accept the same code twice. Thus the code recorded and played back by the thief's code-grabber will never be accepted by your Concept 60. Only ACG can make a car alarm impervious to code-grabbing, and only Clifford systems have ACG with Random Code Encryption. Tamper-proof ignition immobilization While armed, the system assures that your vehicle is completely immobilized by automatically locking out the ignition system. That means that a thief won't be able to start the engine even if he had a duplicate of your car key. Even if he were to find the system control unit and tear it out of your vehicle, he still would not be able to start your car's engine!Optional starter interrupt With the addition of an optional relay, while the system is armed, the vehicle's starter circuit is electronically disconnected. Our Fault-Proof design ensures that you'll be able to start the engine even in the unlikely event of a system malfunction. 14 Enhanced AutoArmingTM If this feature is enabled and you forget to remotely arm, the system will automatically arm itself 30 seconds after the vehicle doors are closed. For your convenience, if you re-open any door(s) within the 30-second countdown, AutoArming will restart from the beginning once all doors are closed. Concept 60 has these additional AutoArming features: AutoArming enable/disable: If you prefer, you may deactivate or reactivate the AutoArming feature. See User-selectable features on pages 21-25. Visual acknowledgment: Five seconds after you exit the vehicle and close all the doors, the parking lights will flash twice to confirm that the AutoArming countdown is progressing. Then, 25 seconds later, the system will AutoArm. AutoArm & Lock: To ensure you can't accidentally lock your keys inside the car, the system is factory-set not to lock the doors upon AutoArming. To change this setting, see User-selectable features on pages 21-25. User-selectable entry delay: If you temporarily lose the use of your remote controls, you may turn on the 15-second entry delay feature. This allows you to enter the car and silently disarm the system by turning on the ignition within 15 seconds of opening the door. See User-selectable features on pages 21-25. Instant AutoArming bypass: Prevents AutoArming when fueling the vehicle and other times when you wish to temporarily bypass AutoArming. To activate Instant AutoArming Bypass, rapidly turn the ignition switch to "ON" then "OFF. " You will hear a single siren chirp to confirm that the system will not AutoArm. The system reverts to its normal operating mode when you next start the engine. [. . . ] You will hear four chirps to confirm programming of channel 4. NOTE 5: Transmit channel 5 (or other channel of your choosing) of the new remote control. You will hear five chirps to confirm programming of channel 5. NOTE 6: When you hear one chirp, all remotes will have been erased from the system memory. [. . . ]