User manual CLIFFORD 78

[. . . ] (If the system does not immediately respond, release and press the button again. This works better than holding the button down. ) The second remote can be used by a second driver, or kept as a spare. Additional remote controls or batteries can be purchased from any authorized Prime Dealer, or by calling Prime Security toll-free at 1-800-253-0334 (within the U. S. ) or 1-847-215-2233. Electronic Scan Prevention (ESP) Your system also includes ESP, which blocks electronic scanner codes preventing unauthorized operation of your system. 1 AMX78(3) Owner's Manual 0399 Instant Remote Control Code Deletion In the event of a lost or stolen remote control, all remote controls can be erased from the system memory preventing unauthorized system operation. [. . . ] Press the remote control ARM/DISARM button for 3-4 seconds. The siren will sound and the parking lights will flash. If the ignition key is "OFF, " the doors will unlock. If the ignition key is "ON, " the doors will lock. Press the remote control ARM/DISARM button for 1-2 seconds. The siren will shut off and the parking lights will stop flashing. Interior Light Illumination When the alarm system is remotely disarmed, the vehicle interior light(s) will turn on for 30 seconds or until the ignition key is turned on. User-Programmable Passive Door Lock Your system will not automatically lock the doors when the alarm passively arms to prevent the keys and remote from being locked in the vehicle. If you prefer, you can easily program the alarm to automatically lock the doors every time the alarm passive arms. (See the "Programming Table for System Features" on page 9. ) User-Programmable Ignition-Controlled Door Lock/Unlock For the ultimate in security and convenience, your system is programmed to automatically lock your doors when the ignition key is turned "ON" or the engine is started, and will unlock when the ignition key is turned "OFF. " This feature can be programmed ON or OFF. (See the "Programming Table for System Features" on page 9. ) 4 AMX78(3) Owner's Manual 0399 Protected Valet Mode You should place your system in Protected Valet Mode whenever your vehicle is being serviced by mechanics, car wash personnel or driven by valet parking attendants. While in the Protected Valet Mode, all alarm functions are bypassed to prevent unauthorized or accidental arming. Remote-controlled door lock/unlock, trunk release and all optional accessories will still operate. To Turn on Protected Valet Mode 1. Turn the ignition key to the "ON" position or start the engine. Flick the valet switch to the "ON" position. The LED will turn on solid red to indicate the system is in the Protected Valet Mode. Turn the ignition key to the "OFF" position. Turn the ignition key to the "ON" position or start the engine. Flick the valet switch to the "OFF" position. The LED will turn off to indicate the system is no longer in the Protected Valet Mode. Turn the ignition key to the "OFF" position. LED System Status Indicator The LED on your vehicles dashboard or center console will inform you of the system status. LED Off On solid Slow flash Flashing in cycles Rapid flash Status System is disarmed In Protected Valet Mode System is armed See "Specific Intrusion Identification" on page 6. Passive arming Remote-Controlled Trunk Release Capability If you have the optional Trunk Release installed, simply press the remote control TRUNK button for 1-2 seconds to activate your vehicle electronic trunk release. The trunk will "pop" open (may require an optional relay). 5 AMX78(3) Owner's Manual 0399 Remote-Controlled Accessory Output This output allows you to add an optional remote-controlled accessory to your system such as a remote engine starter, window roll-up, garage door opener* or fuel door release. [. . . ] Turn the ignition key to the "ON" position. Within 10 seconds, begin flicking the valet switch on and off. The siren will chirp once each time you flick the switch on then off. Continue flicking the switch on and off, counting the number of chirps. [. . . ]