User manual CLIFFORD MATRIX RS

[. . . ] Matrix RS O Owner's Guide limited lifetime consumer warranty Directed Electronics, Inc. ("Directed®") promises to the original purchaser to repair or replace with a comparable reconditioned model any Directed® unit (hereafter the "unit"), excluding without limitation the siren, the remote transmitters, the associated sensors and accessories, which proves to be defective in workmanship or material under reasonable use during the lifetime of the vehicle provided the following conditions are met: the unit was professionally installed and serviced by an authorized Directed® dealer; the unit will be professionally reinstalled in the vehicle in which it was originally installed by an authorized Directed® dealer; and the unit is returned to Directed®, shipping prepaid with a legible copy of the bill of sale or other dated proof of purchase bearing the following information: consumer's name, telephone number and address; the authorized dealers name, telephone number and address; complete product description, including accessories; the year, make and model of the vehicle; vehicle license number and vehicle identification number. All components other than the unit, including without limitation the siren, the remote transmitters and the associated sensors and accessories, carry a one-year warranty from the date of purchase of the same. This warranty is non-transferable and is automatically void if: the original purchaser has not completed the warranty card and mailed it within ten (10) days of the date of purchase to the address listed on the card; the unit's date code or serial number is defaced, missing or altered; the unit has been modified or used in a manner contrary to its intended purpose; the unit has been damaged by accident, unreasonable use, neglect, improper service, installation or other causes not arising out of defects in materials or construction. [. . . ] The LED status indicator will stop DRW-35 flashing and the vehicle should start. If it does not start, you may have waited too long; turn the ignition off and repeat the process. Location of Valet Switch_________________________________ valet mode You can prevent your system from automatically activating the starter interrupt and locking the doors by using Valet Mode. Valet Mode is very useful when washing the vehicle or having it serviced. In Valet Mode, the starter interrupt cannot be activated, even with the remote, but all convenience functions (door locks, remote engine starting, etc. ) will continue to work normally. To enter or exit Valet Mode: 1. Press and release the Valet switch DRW-35 within 10 seconds. The LED status indicator will light steadily if you are entering Valet Mode and will turn off if you are exiting Valet Mode. © 2001 directed electronics, inc. 9 panic mode If you are threatened in or near your vehicle, you can attract attention by triggering the system with your transmitter. Just press and hold for 1. 5 seconds to enter Panic Mode. Panic Mode, the horn will honk and the parking lights will flash for 30 seconds. To stop Panic Mode at any time, press note: In order for Panic Mode to be effective, the vehicle's horn (or optional siren) as well as the vehicle's parking lights must be connected. remote engine starting This feature allows you to remotely start and run your vehicle for a programmable period of time. This makes it possible to warm up the engine, as well as adjust the interior temperature of the vehicle with the climate control system. If interior heating or cooling is desired, the climate controls must be preset, and the fan blower must be set to the desired level prior to remote starting the vehicle. important!(1) Never remotely start the vehicle with the vehicle in gear, and (2) Never remotely start the vehicle with the key in the ignition. To remote start the vehicle: 1. Press on the transmitter for one second. 2. The parking lights will flash to confirm that the vehicle will attempt to start. 10 © 2001 directed electronics, inc. 3. Release the button as soon as the parking lights flash. (In gasoline vehicles, the engine will start 3 seconds after the parking lights flash. In diesel vehicles, the engine will start when the wait-to-start indicator on the vehicle's dash goes out. ) 4. Once the vehicle has started, it will run for the pre-programmed period of time (either 12, 24, or 60 minutes - see Programming Options section of this guide) or until a shutdown input is triggered. When you are ready to drive the vehicle: 1. Insert the ignition key and turn it to the ON (not the START) position. Press the brake pedal. note: If the brake pedal is pressed before the key is in the ON position, the engine will shut down. shutting down the remote start system While the vehicle is running during remote engine starting operation, the system will monitor the vehicle and will automatically shut down the engine if the system receives any of the following shut-down inputs: The brake pedal is pressed. The hood is opened. 11 © 2001 directed electronics, inc. The shutdown toggle switch is put into the OFF position. The pre-programmed run time (12, 24, or 60 minutes) has elapsed. is pressed during remote start operation. To shut down the remote start and turn off the engine: Step on the brake pedal, or Press for one second. valet take-over The Valet Take-Over feature allows the vehicle to remain running after the key has been removed from the ignition. [. . . ] This is useful for seeing inside the vehicle at night prior to entering it. Power Door Lock Control: Your system is capable of controlling many types of power door lock systems; however, some door lock systems may require extra parts. Consult with your dealer to determine which type of locks your vehicle uses. If power locks are connected, the system can be programmed to lock the doors automatically 30 seconds after the ignition has been turned off. The system can also be programmed to lock the doors when the ignition is turned on and to unlock them when the ignition is turned off. Power Trunk Release: The system's auxiliary output can be programmed to operate a factory power release for the vehicle's trunk or hatch. [. . . ]