User manual COBRA ESD6050

[. . . ] WARNING: Before leaving your car, make sure that you conceal your radar detector. This will reduce the possibility of break-in and theft of your unit. 1. 2. Included with your ESD-6050 LE 3. Power Cord A1 Controls and Indicators 1. [. . . ] In Auto mode, the alarm will be reduced in volume after four seconds. Mute Note Factory default setting is Highway Mode. Manual Mode Press & Release 1 Press and release MUTE button anytime to turn off the audio alert. Mute 8 9 Detection Radar Radar The display will show the band (X, K/Ka). The signal strength will be indicated by increasing frequency of the beeps and the blinking indicators. Detection VG-2 Undetectable The Cobra® ESD-6050 LE is undetectable by police VG-2 detection devices. It will alert you when one is in use near your vehicle. VG-2 Alert® The L/W LED on the front of the unit will blink. Instant-On Detection Instant-On Detection The Cobra® ESD-6050 LE is also designed to detect Instant-on speed monitoring signals. Immediate action is required when warning is given. Laser The L/W LED will blink. Laser Detection with 360° LaserEye® Note The display does not indicate signal strength for VG-2, Safety and Laser alerts. Safety Alert® Traffic Warning System Safety Alert® Traffic Warning System Indicator "L/W"will blink. MUTE CITY 10 11 Detection Radar/VG-2/ Laser Alerts Radar/VG-2/Laser Alerts Type of Audible Signal Your COBRA® ESD-6050 LE starts to signal slowly, then increases in rate very rapidly. Your COBRA® ESD-6050 LE signals just once. Slow signal rate as you approach hill or bridge. Sharp increase in signal rate as you reach hill or bridge. Short-term, weak signaling; series of such signals. Laser Interpretation and Response Most likely police radar. Most likely a false source, or could be pulsed radar. Radar or VG-2 close by has been suddenly switched on. Most likely police radar on other side of hill or bridge. There are no false laser signals. Detection Facts About the Safety Alert® Traffic Warning System FCC-approved Safety Alert Transmitters emit microwave radar signals to indicate the presence of a safety-related concern. Depending on the frequency of these signals, as set on the transmitter, the outgoing signal can indicate whether the transmitter is on a speeding emergency vehicle or train, or at a stationary road hazard location. These microwave signals are located in the K-band and as a result, any radar detector which detects K-band radar will detect these Safety signals as standard K-band radar alerts. However, unlike a standard radar detector, your Cobra® ESD-6050 LE is designed to differentiate between a standard K-band alert and a Safety Alert warning. Safety technology is relatively new so the number of transmitters in operation is still growing. Not as quickly, but it does spread, as shown on the diagram below. 5 FT. WIDE Maintenance Your COBRA® ESD-6050 LE RADAR/LASER DETECTOR will give you years of trouble-free service with minimum maintenance. Replacing Power Cord Fuse Unscrew cap of cigarette lighter adapter and remove fuse. Troubleshooting If your COBRA® LASER DETECTOR ESD-6050 LE isn't operating, we suggest you make the following checks: 1. Is the cigarette lighter socket clean and free from corrosion?15 Maintenance LASER LIGHT EMISSION DETECTABLE BY COBRA POLICE LASER GUN LASER GUN READABLE RANGE 1/4 MILE 1/2 MILE 1MILE 11/2MILE 14 Specifications Specifications GENERAL SPECIFICATIONS A. [. . . ] If possible, use the original packing material. Ship prepaid and insured by way of a traceable carrier such as United Parcel Service (UPS) or First Class Mail to: Cobra® Factory Service, Cobra® Electronics Corporation, 6500 West Cortland Street, Chicago, IL 60707 USA. If the unit is in warranty, upon receipt of your unit it will either be repaired or exchanged depending on the model. Please allow approximately 3 to 4 weeks before contacting us for status. [. . . ]