User manual COBRA MICROTALK MT 975

[. . . ] 10376 MT975UK. qxd 1/15/08 4:05 PM Page 1 Two-Way Radio Model MT 975 ENGLISH 1. Lock Tab 12 9 4 1 2 11 10 3 8 5 6 13 7 14 Product Features · Two-Way Radio with up to a 12 km (7. 5 mile) range · 8 Channels* · 38 CTCSS Privacy Codes · 83 DCS Privacy Codes · 10 Channel Memory · Backlit LCD Display · Battery Saver Circuitry · Battery Level Meter · Maximum Range Extender · VOX Mode for Hands-Free Transmissions · Intercom Capable · Baby Monitor Function · VibrAlert® Silent Paging · Call Alert 10 Selectable Tones · Scan Channels, Privacy Codes, Memory · Dual Watch Programmable 2-Location Scan · Key Lock · Auto Squelch · Selectable ON/OFF "Roger Beep" Confirmation Tone · Selectable ON/OFF Keystroke Tone · Combination Speaker/Microphone Jack · Belt Clip *You are not allowed to use channels 1 and 2 in France. This situation can change; please contact the French radio licensing authority for more information. 2 1 18 17 7 16 15 14 13 12 11 10 9 8 3 4 5 6 1. [. . . ] Press the TALK button to enter the channel/privacy code in the selected memory location and exit MODE functions. Upon release of the TALK button, the radio will enter LISTENING MODE on the channel/privacy code just entered. To Recall a Stored Memory Channel Location: 1. Press the MODE button until the Memory icon and the memory location number flash on the display. Press the CHANNEL UP or CHANNEL DOWN button to select a memory location (0 through 9). NOTE: If a location has been programmed before, its associated channel/privacy code will be shown on the display. Press the TALK button to return to LISTENING MODE on the selected memory location. NOTE: A memory location can be reprogrammed at any time it is displayed and flashing. While recalling a stored memory location, if you do not press any buttons for 15 seconds, your radio will automatically return to LISTENING MODE on the channel/privacy code displayed before you entered MODE functions. Press the MODE button until the Memory icon and the memory location flash on the display. English Channel Scan Your microTALK® radio can automatically scan channels (1 to 8). NOTE: The radio ignores specific CTCSS or DCS privacy codes while scanning channels. To Scan Channels: Select Scan Channels 1. Press the MODE button until the Scan icon and the channel number flash on the display. Press the CHANNEL UP or CHANNEL DOWN button to begin scanning channels. The Scan icon will continue to be displayed when channel scan is ON. Your radio will continue to scan all channels and stop if an incoming transmission is detected. Your radio will remain on that channel for 10 seconds. During An Incoming Transmission, You Can Choose From The Following: a. Press and hold the TALK button to communicate on that channel. Your radio will remain on that channel and return to LISTENING MODE. Press the CHANNEL UP or CHANNEL DOWN button to resume scanning channels. If you do not press any button within 10 seconds, your radio will automatically resume scanning channels. 2. [. . . ] Press the LOCK/ENTER button to enter the ON setting and enter BABY MONITOR MODE. NOTES: Pressing the MODE button will enter the BABY MONITOR MODE setting as OFF and proceed to other MODE functions. Not pressing any buttons for 15 seconds will enter the BABY MONITOR MODE setting as OFF and return the radio to LISTENING MODE. NOTE: Both radios must be tuned to the same channel and privacy code to communicate. To Terminate Baby Monitor Mode: Choose one of the following: a. [. . . ]