User manual COBRA XR S9530

[. . . ] Introduction Intro Important Information and Customer Assistance Operation Customer Warranty Assistance Important Information Federal Laws Governing the Use of Radar Detectors It is not against federal law to receive radar transmissions with your Cobra radar/ laser detector. The Communications Act of 1924 guarantees your right to receive radio Secondary Icons transmissions on any frequency. Local laws that contravene this Act, while illegal, may be enforced by your local law enforcement officials until and unless they are prohibited from doing so by federal court action. Operating Instructions Safety Alert Use of this product is not intended to, and does not, ensure that motorists or passengers will not be involved in traffic accidents. [. . . ] Customer Warranty Assistance You can reset the activation point at any time to fit your individual preferences and driving style. Customer Setting the IntelliMute Activation Point Assistance Your detector must be installed in your vehicle. Rev your engine to None the level you wish to set (recommend slightly above idle) and hold revs Intro steady Operation for two seconds. At the desired rev level, press and release the Secondary Icons IntelliMute button. IntelliMute Not Set IntelliMu. . . Notice None Customer Assistance Warranty Three beeps IntelliMute Set IntelliMute Set! Installation Notice Caution CAUTION Do not attempt to set the rev point while driving. Warning Your vehicle should be parked and idling. Please tr. . . NOTE If the unit is unable to sense usable pulses within three seconds or if you do not set a rev point within 20 seconds of beginning these steps, IntelliMute will indicate an error and automatically turn off. Tone Four beeps Voice IntelliMute Not Set, Please Try Again followed by IntelliMute Off Visual Display IntelliMute not set Please try again IntelliMute Off 11 IntelliMute Off IntelliMute must be turned on before setting the activation point. Depending on whether the unit is in Tone Alert or Voice Alert mode, you will hear a series of beeps or voice messages as you follow the steps on page 11. Intelli Mute Off One beep 10 English Nothing Comes Close to a Cobra® Your Detector Intro Operation Settings Customer Warranty Your Detector Intro Operation Settings Customer Warranty Assistance Voice/Tone Setting Assistance Spectre 1, VG-2 Alert Audio Settings, K & Ku Band Detection You can set your detector to sound alerts with either a Voice or a Tone. You can change settings by using the Mute button. Secondary Icons In Voice Alert mode, you will first hear several tones, then a voice message announcing the type of signal detected, followed by more tones. In Tone Alert mode, you will hear the tones only. The factory setting is Voice Alert mode. Notice The detector is undetectable by police Spectre 1 and VG-2 radar detector detectors and will alert you when such a device is in use near your vehicle. During the alert, the unit continues to detect other signals. You can choose whether or not you want your unit to Secondary Icons Spectre 1 and VG-2 alerts. The factory setting is Spectre 1 and VG-2 alert off. show Spectre 1 and VG-2 On Spectre 1 and VG-2 Off Spectre1 Notice Spectre1 & VG2 Dim Button Press and hold for two seconds Mute Button Press and hold for two seconds City Button Press and hold for two seconds & VG2 On Off To Turn Spectre 1 and VG-2 Alerts On and Off While no signal is being detected, press and hold the Dim button for two seconds. Tone Two beeps One beep Voice Spectre VG-2 On Spectre VG-2 Off Visual Display Spectre1 & VG 2 On Spectre1 & VG 2 Off To Change From Voice Alert to Tone Alert While no signal is being detected, press and hold the Mute button for two seconds. Tone One beep Voice Tone Alert Visual Display None To Turn K Band On and Off While no signal is being detected, press and hold both the Dim and City buttons for two seconds. Tone Two beeps One beep Voice K On K Off Visual Display K On K Off To Change From Tone Alert Back to Voice Alert While no signal is being detected, press and hold the Mute button for two seconds again. Tone None Voice Voice Alert Visual Display None To Turn Ku Band* On and Off While no signal is being detected, press and hold the City button for two seconds. Tone Two beeps One beep Voice Ku On Ku Off Visual Display Ku On Ku Off Nothing Comes Close to a Cobra® 13 12 English * The new Ku band may be introduced to North America in the future. To prevent false alerts until it is, the factory default for Ku band detection is off. Your Detector Intro Operation Detection Customer Warranty Your Detector Intro Operation Detection Customer Assistance Warranty Detection Assistance Signals Detected Secondary Icons · Radar Signals, Voice and Visual Displays Type of Signal X Band Radar Secondary Icons Voice X Alert K Alert Ka Alert Ku Alert K Signal Detected Ka Signal Detected Visual Display X and Signal Strength K and Signal Strength Ka and Signal Strength Ku and Signal Strength Ku Signal Detected The tables on the following pages show you the types of Signals your detector will detect, as well as the voice and visual alerts it provides for each of them. K Band Radar Ka Band Radar Ku Band Radar Audio Alerts In Voice Alert mode you will first hear several tones, then a voice message announcing the type of signal detected, followed by more tones. In Tone Alert mode, you will hear the tones only. In both Voice Alert and Tone Alert modes, a distinctly different alert tone is used for each type of signal detected (including separate tones for each laser signal). For X, K, Ka and Ku band radar signals, the tones will repeat faster as you approach the signal source. The repeat rate of the tones gives you useful information about the signal detected. [. . . ] If the owner of the product resides outside the U. S. A. All implied warranties, including warranties of merchantability and fitness for a particular purpose are limited in duration to the length of this warranty. Cobra shall not be liable for any incidental, consequential or other damages; including, without limitation, damages resulting from loss of use or cost of installation. Some states do not allow limitations on how long an implied warranty lasts and/or do not allow the exclusion or limitation of incidental or consequential damages, so the above limitations may not apply to you. Notice If Cobra asks that the product be sent to its factory, the following must be furnished to have the product serviced and returned: 1) Send the complete unit, including power cord. [. . . ]