User manual COBRA XRS 9600 RADAR DECTECTOR

[. . . ] Operating Instructions 11 BANDTM ULTRA HIGH-PERFORMANCE DIGITAL RADAR/LASER DETECTOR WITH XTREME RANGE SUPERHETERODYNETM TECHNOLOGY XRS 9600 Nothing comes close to a Cobra® Printed in China Part No. 480-106-P English Introduction Important Information And Customer Assistance · Important Information Federal Laws Governing The Use Of Radar Detectors It is not against federal law to receive radar transmissions with your Cobra radar/ laser detector. The Communications Act of 1924 guarantees your right to receive radio transmissions on any frequency. Local laws that contravene this Act, while illegal, may be enforced by your local law enforcement officials until and unless they are prohibited from doing so by federal court action. [. . . ] The compass will remain accurately calibrated as long as your detector is mounted in the same place in your vehicle. If you change the location where the unit is mounted or move it to another vehicle, you must recalibrate the compass. The compass temporarily may not provide accurate readings if you are inside a building or enclosure, or are close to a large metal tractor/trailer, truck, or train. Once you are away from such a location, the compass will work correctly again. NOTE When the instructions direct you to drive in two (2) circles, a large parking lot is the most convenient place to do so. It does not matter what direction your vehicle is pointing when you start the circles, which direction you go to make the circles, and it does not have to be exactly two (2) circles. You do NOT have to make perfect circles. You can drive in any pattern, as long as you make two (2) complete turns. Four (4) three-point turns, two (2) small squares, or any two (2) complete loops will work as well as two (2) circles. It does not matter what size the circles are, if your speed is constant, or how fast you make the circles [but less than two (2) minutes]. Please be careful when making the circles and watch for other traffic. 16 English In Program mode, go to Set Compass. Press and hold the Set/City button to begin setting the compass. Within two (2) minutes, drive your vehicle in a circle twice, then press the Set/City button again. Tone None One (1) beep Visual Display Set Compass Drive in 2 circles. . . For two (2) seconds followed by direction of travel (N, NE, E, SE, S, SW, W or NW) None Three (3) beeps Press and release either the Select/Dim None button to proceed to the next user mode or the Program/Mute button to exit Program mode. Set Compass Calibrate Compass Compass Set Direction Of Travel Set Compa. . . Drive in. . . Press SET. . . Compass Set! NW h NOTE If you do not press the Set/City button within two (2) minutes after beginning the set compass process, compass calibration will automatically terminate. Terminate Tone One (1) beep Visual Display Compass n. . . Compass not set. . . Please try again. . . Please tr. . . Nothing comes close to a Cobra® 17 Your Detector Settings Your Detector Settings Pop Alert Pop Alert will alert you of Pop radar signals. During the alert, the unit continues to detect other signals. The factory setting is Pop Detect off. To Turn Pop Detect Mode On Or Off Using Program Mode (See Page 7 For Instructions On Using Program Mode) VG-2 Alert The detector is undetectable by VG-2 detection devices and will alert you when such a device is in use near your vehicle. During the alert, the unit continues to detect other signals. You can choose whether or not you want your unit to show VG-2 Alerts. With VG-2 Detect mode on, you can also choose whether or not you want your unit to sound audible VG-2 Alerts. The factory settings are VG-2 Detect on and VG-2 Detect Audio on. In Program mode, go to Pop Detect. Tone Two (2) beeps One (1) beep Pop Detect On Visual Display Pop On Pop Off Pop Detect Off To Turn VG-2 Detect Mode Off Or On Using Program Mode (See Page 7 For Instructions On Using Program Mode) In Program mode, go to VG-2 Detect. Tone One (1) beep Two (2) beeps VG-2 Detect Off Visual Display VG2 Off VG2 On VG-2 Detect On Pop On Pop Off VG2 Off VG2 On To Turn VG-2 Audio Mode Off Or On Using Program Mode (See Page 7 For Instructions On Using Program Mode) In Program mode, go to VG-2 Audio. Tone One (1) beep Two (2) beeps VG-2 Audio Off Visual Display VG2 Audio Off VG2 Audio On VG-2 Audio On . . . Audio Off . . . Audio On 18 English Nothing comes close to a Cobra® 19 Your Detector Settings Your Detector Settings Spectre 1 Alert The detector is undetectable by Spectre 1 detection devices and will alert you when such a device is in use near your vehicle. [. . . ] 20-20 and Ultra-Lyte are trademarks of Laser Technology, Inc. ProLaser and ProLaser III are trademarks of Kustom Signals, Inc. Bee III and Pop are a trademarks of MPH Industries. Interceptor VG-2 is a trademark of TechniSonic Industries LTD. [. . . ]