User manual COBRA XRS R9G

[. . . ] IntelliLinkTM Wireless Remote Series 12-BandTM S-XRSTM Maximum Performance Digital Radar/Laser Detector with Red Light/Speed Camera GPS Locator* Introduction Important Information and Customer Assistance · Important Information Safe Driving Motorists are expected to exercise all due caution while using this product, and to obey all applicable traffic laws. Do not attempt to change settings of the unit while the car is in motion. Federal Laws Governing the Use of Radar Detectors It is not against federal law to receive radar transmissions with your Cobra® radar/laser detector. The Communications Act of 1924 guarantees your right to receive radio transmissions on any frequency. [. . . ] Press and hold the vehicle accelerator at desired engine RPMs. System stores engine RPM setting and displays a completion message and a tone or voice message. Unit must sense a usable pulse within three seconds or a set RPM point within 30 seconds of beginning of setup, or IntelliMute detects an error and turns off. Change a set activation point by accessing Set IntelliMute in User Settings Programming. Repeat three-step setup process above. Auto Mute Mode When Auto Mute is on, it automatically reduces the audio volume of all alerts after they have sounded for four seconds. The signals will remain muted for as long as the signal is detected. When Auto Mute is off, the alerts will sound at full volume for as long as the signal is detected. The factory setting for Auto Mute is On. Press MUTE/ to toggle between Auto Mute vs. Manual Mute. Voice or Tone Mode Set detector to sound alerts and confirm program settings with a Voice or a Tone. Voice Alert provides voice messages in addition to tones. Factory setting is Voice Alert. Remote Display Unit (RDU) Beep Level RDU Beep sets the volume level for the keypad confirmation tones of the RDU. Choose from low, high or off RDU beep level volumes. RDU Display Color The RDU screen color theme is customizable to match your personal preference or your vehicle's dash illumination. Choices include Multi-Color, Red, Blue, Orange or Green. Factory setting is Multi-Color. Nothing Comes Close to a Cobra® 25 Your Detector Settings Display Setup Display Setup determines how long RDU button backlight and display stays on before RDU screen switches to Auto Dark mode. Set RDU display time for 15 seconds, 30 seconds, one minute, three minutes or Always On. NOTE: If selecting "Always On" setting, RDU battery will need charging more frequently. Smart Power Mode SmartPower feature turns system off five minutes after car's engine is turned off. Before SmartPower engages, three beeps sound and SmartPower flashes on display. Start the car or press Power/Pairing button to return to normal power. Factory setting is SmartPower On. Speed Indicator (Shown only if GPSL is connected) Displays vehicle speed in miles per hour (MPH) or kilometers per hour (km/h). Factory setting is MPH. Restore Factory Settings Restore detector to original settings here. Confirmation messages display during process. 26 English Your Detector Settings · Programming Alert Settings POP Alert With Pop Detect mode on, signals are detected and an alert given. [. . . ] For Warranty Repair, include some form of proof-of-purchase, such as a mechanical reproduction or carbon of a sales receipt. Make sure the date of purchase and product model number is clearly readable. If the originals are sent, they cannot be returned. Send the entire product except for hardwired or permanently placed components such as 12V hardwire power cord and cord clips. [. . . ]